2000 Tohatsu M40D2 40 hp . I need the manual valve assy for the tilt & trim. Part# 3Z5771750. If you have one or know where I can get one please leave info on this forum.Thank you
OK I think i have all of the air purged out because it goes up and down fine now. The only problem now is when i let the motor up it slowly creeps back down. Sounds like one of the valves is not closing off. Which one could it be. Thanks for the help
I have a 2000 Tohatsu 40 hp and the t&t stopped working. The trim motor works fine. I have opened the relief valve to manual and purged the air out several times. When I lift the motor up and down I only get resistance at the top and bottom of the stroke. It seems to be nothing in the middle...
The other day I was fishing and deployed my Minn Kota Terrova. Most of the time I use the remote around my neck. Well I was trolling and I noticed my trolling motor moving like it was in auto pilot. I looked at the remote and sure enuff it was. I took it out of auto and several seconds later it...
2016 mercury 115, I put a vessel view on it and it sure don’t seem like I’m putting as many hours on the motor as vessel view is showing. Does anyone else have the issue?
2000 Tohatsu M40D2 2 stroke .I cleaned carbs and put new needle valves and new diaphragm in fuel pump. I pump the bubble and it takes choking it to get it to start and runs like crap.I removed the plugs and all three are satuated with fuel. are the check valves in the fuel pump suppose to be...