Logo
FULL SITE MENU

Recent content by dmc

  1. D

    Water in the bilge OMC Cobra

    I finally got the boat in the I finally got the boat in the water after 1 1/2 years of working on the repowing project. I noticed more water coming in than I remember. When I got back on the trailer I noticed water leaking out from the bottom of the Transom Gimbal Housing (the part of the...
  2. D

    Oil tube on 1990 43L

    Has anyone found a inexpensive Has anyone found a inexpensive set up for checking and drawing the oil out on a 4.3L engine. I repowered the boat the we somehow lost the dip tube and stick from the old engine. To get the original OMC parts including the pan fitting its over $100. I dont care...
  3. D

    1990 43L starter wiring question

    "Can someone tell me what the "Can someone tell me what the function and status are of the 3 terminals on the starter. I would like specifically what happens to the purple/black wire while the ket is in "run" and "start" http://www.selocmarine.com/content/manuals/3404/pdf/340410w151.pdf"
  4. D

    New Engine and Electronic Ignition Conversion

    "I finally got a rebuilt 1990 "I finally got a rebuilt 1990 4.3L OMC in the boat and something is different with the elcetrical. I used a few of the parts from the oldengine set up including my Prestolite Breakerless Ignition with eh Shift Module kit. When I installed that kit a few years...
  5. D

    Exhuast down tubes OMC differences

    Help. This might be a tough o Help. This might be a tough one. Lets see who is a true genius. Im trying to see what the differences are in the 2 Exhuast down tubes with the following part numbers. SO far I know they are specified for 2 different engines a v8 and v6 but what are the...
  6. D

    Fuel Pump rebuild OMC 43

    Does anyone know if a kit is a Does anyone know if a kit is available for the Carter M60201 Feul Pump. I rather not drop another $100 bucks. Thanks for the help
  7. D

    OMC 1990 43 part numbers vs Mercruiser

    "Im dropping in a new engine a "Im dropping in a new engine after toasting my OMC 4.3L 1990 I spent a few weeks looking for exhaust that will replace the one piece OMC. The OMC kits online are way too expensive for just manifolds. Im looking to go with merc parts whenever possible. Has...
See more
Back
Top