Logo
FULL SITE MENU

Recent content by James Ha

  1. J

    Help Please !!!

    1983 Evinrude 60hp E60ELCTB When I was flushing my motor I noticed something I haven't seen before. Where the lower unit bolts to the mid section on the leading edge (front) There is a 1/8 square hole . IS that supposed to be there? Also the decal that is there has a cutout over that area. When...
  2. J

    Engine test propeller

    How large a water tank should I have for a 60hp motor
  3. J

    Engine test propeller

    Where can I get one of these test wheels for my 60hp motor
  4. J

    1983 Evinrude 60hp Model E60ELCTB

    Note: This motor is on a pontoon boat
  5. J

    1983 Evinrude 60hp Model E60ELCTB

    Overheat horn works on the remote. Only used it a couple of times last year, still working out some issues. Top & bottom have been rebuilt buy Experienced service man. After sitting for umteen years the thermostat is probably not working as it should. It seems to run fine but I can't be sure...
  6. J

    1983 Evinrude 60hp Model E60ELCTB

    I want to add a Water Temp Gauge to my motor. Did not have one previously. Can you make a recommendation. I currently have Faria Tachometer.
  7. J

    Starter pinion gear

    Cold compression test / 4.2024 Cyl #1. 152 psi Cyl #2. 147 psi
  8. J

    Starter pinion gear

    Thanks
  9. J

    Starter pinion gear

    Yes it does It was sitting for years with someone else, just started using it lately. The starter does start the moter.
  10. J

    Starter pinion gear

    Model E60ELCTB
  11. J

    Starter pinion gear

    1983 Evinrude 60hp
  12. J

    Starter pinion gear

    My starter pinion gear only goes up halfway on the flywheel. Is this normal, if not, what to do?
See more
Back
Top