Logo
FULL SITE MENU

Recent content by kevinc1820

  1. K

    Gear rod connection

    Should have said its a 1996 9.9hp johnson
  2. K

    Gear rod connection

    I am looking for some help. I don't know if I have lost a part but how do I connect these gear sections together the rod is to big for the hole
  3. K

    Clooling problem

    I took the power head off and I gave it a good clean there was build up of sand and salt all over the place. Under the air cover where the tell-tail connects was really bad. That may have been the cause. I am waiting on the gasket kit coming then i can put it all back together. Is there anything...
  4. K

    Clooling problem

    Hi. I had the test bucket filled all the way up to thr top of the lower unit. Can you think of anything else to try before taking off the power head
  5. K

    Clooling problem

    I have done some further checks. I dropped the lower unit again and placed it in a tub of water. I then turned the drive shaft and there was plenty of water coming from the water pump. I then attached a hose to the copper inlet water pipe the water came through the tell-tale but there was a lot...
  6. K

    Clooling problem

    It was an aftermarket impeller that looked the same as the original one. The old one didn't look that bad either to be fair. I rotated the drive shaft clockwise when I mounted the water pump.
  7. K

    Clooling problem

    Sorry its a 1996 johnson 9.9.9hp with pull cord. I changed the thermostat today still the same. I tried putting an air compressor through the tell-tale again and noticed air coming from this point where the gear linkage comed through. Any help would be great
  8. K

    Clooling problem

    Hi all i am having an issue with intermittent water coming out of the tell-tale. I have changed the impeller and blown air through the tell-tale with lots of air coming from the intake. The water pump seems in good condition but I will change it to see. Can anyone think of another reason its not...
See more
Back
Top