Logo

Recent content by Tommy2t

  1. Tommy2t

    Nissan 9.8 2-stroke pull start

    Very easy motor to work on, get a carb kit (oem) and replace the water pump. After that long in storage it's the least you should do.
  2. Tommy2t

    Adhesive or no adhesive when changing the exhaust cover on 86 Mercury 9.9 outboard

    Yes Permatex avation form a gasket is very similar and will work fine.
  3. Tommy2t

    9.9 to 20 hp parts

    The ecu controls the max RPM which i think is 6000 on the 20hp it also controls the fueling., Different part #'s so i would think it is necessary.
  4. Tommy2t

    KAD31 Oil Leak

    Rebuild or replace.
  5. Tommy2t

    KAD31 Oil Leak

    Most likely the turbo is leaking into the cooler, pull the insert and see if it's covered with oil.
  6. Tommy2t

    M8B thrust holder for the propeller stuck

    I had some fishing line around the shaft and wanted to check behind the thrust holder to make sure the seal is clear.
  7. Tommy2t

    M8B thrust holder for the propeller stuck

    M8B thrust holder is stuck on the prop shaft, any tips for removal? This is a salt water motor and it seems to be corrosion holding it on.
  8. Tommy2t

    Fuel leak

    Move the boat out of the garage ASAP! Check the vent hose on top of the tank.
  9. Tommy2t

    TAMD 41B problem

    # 30 is the O-rings and check # 29 for cracks
  10. Tommy2t

    TAMD 41B problem

    Boatdiesel dot com has a wealth of knowledge on these motors
  11. Tommy2t

    TAMD 41B problem

    I had a similar problem on my 41B and it turned out to be the oil feed to the rocker shaft, 2 O rings. Run the motor with the back valve cover removed and look for excess oil coming up from the rear of the head. What happens is the oil floods the rear valve cover and spills out of the breather...
  12. Tommy2t

    Removing Volvo Penta D3-200 Turbo

    Use this style wrench...
  13. Tommy2t

    DB Electrical tilt/trim

    I used them for a starter on my Volvo diesel with no problems, much less $ than oem Volvo. 2 seasons in and working as it should.
  14. Tommy2t

    Suzuki DT3.5 not sparking

    Kill switch is shorted out and needs to be replaced.
Back
Top