Logo

Recent content by turkeyhunter

  1. T

    reed valve help

    I have pulled my reed valves and there is none that are broke or cracked but there are some that when you hold it up to the light you can see a lot of light coming threw will that my boat not run right at wot and at idle
  2. T

    mercury xr6 150 missing at wot

    i put the timing light on each plug and saw no change
  3. T

    mercury xr6 150 missing at wot

    I am not sure what you mean am i looking for a bad coil do i need to be on the lake or can i use muffs
  4. T

    mercury xr6 150 missing at wot

    need a little help i have rebuilt the carbs fixed the oiler rebuilt the fuel pump did the link and sink on the carbs is was hesitating at wot so i backed out the jets from 1-1/4 turns to 2 turns out got some of the hesitating out but then it starting missing when you increase speed what am i...
  5. T

    2002 mercury 150 2 stroke

    racerone I have the mixture screws backed out to 1-3/4 turns out getting better but now at wot it seems like its missing al little could i have bad gas but it doesn't do it when the mixture screws are 1-1/2 turns out but that's where it hessites at its better at the 1-3/4 turns out but just...
  6. T

    2002 mercury 150 2 stroke

    racerone I started at the 1 1/4 turns out on the carbs and went in 1/8' turn until 1 1/2 and it didn't change could i have a bad reed valve
  7. T

    2002 mercury 150 2 stroke

    I still need a little help please
  8. T

    2002 mercury 150 2 stroke

    sorry muc it's been a while I took it a machinic and he didn't fix it it has been link and sink and put new gas in the tank had the auto oiler cleaned and flushed and it still hessites when trying to get on plane the only thing i can think of is do i have a bad reed valve
  9. T

    2002 mercury 150 2 stroke

    Hi i have a mercury 150 2 stroke xr6 I rebuilt the carburetors because when i try to go on plane the motor hessites for 2 sec then takes off and runs fine but it is still doing it after the rebuild, could it be out of time or could the floats not be set right the motor has low hrs less then 300 hrs
  10. T

    2007 yamaha f150 bogs down on take off

    I Have a 2007 yamaha F150 starts up fine runs with muffs on but when i put it in the water and try to take off it takes off and then bogs down and wont go but it will ideal anyone have any ideas
  11. T

    minn kota Edge 70 help

    Has anyone tried to convert or use a fortrex80 lb thrust lower unit and put it on a edge 70 lb thrust unit I am trying to turn my 70lb edge into 80 lb thrust just wanted To know IF you could take a fortrex 80 lb lower unit and put i on a edge 70 lb unit. I on' have $1500 to $2000 to spend on...
Back
Top