Logo
FULL SITE MENU

Recent content by YamaNoob06

  1. Y

    2005 Yamaha Trim Motor Replacement

    Just a quick bump to see if anyone knows if there is another fastener I need to remove to access the connection for the tilt motor and sender. I have removed the 4 nuts on each side of the exhaust and 3 bolts in front of the motor shown above. Thank you all for your help. 🙏 JC
  2. Y

    2005 Yamaha Trim Motor Replacement

    I believe the tilt sender is the green and the red is the tilt motor. They both move when I pull the wires going through the bottom of the motor. I’m just having trouble accessing the area where they’re connected.
  3. Y

    2005 Yamaha Trim Motor Replacement

    I get an error with all the pictures. I’ll have to attempt again later.
  4. Y

    2005 Yamaha Trim Motor Replacement

    Ok, I got a bit further down the road. I disengaged the brackets which were holding the engine tilted forward. I removed four nuts, 2 on each side of the intake/exhaust, and 3 bolts in an attempt to remove the intake manifold. Unfortunately, I couldn’t remove the intake to better access and...
  5. Y

    2005 Yamaha Trim Motor Replacement

    Knew that. You passed the test.
  6. Y

    2005 Yamaha Trim Motor Replacement

    Will do. I can see the wires go under the motor through a retention tab. After reviewing at your latest schematics it looks like I need to remove the exhaust manifold to uncover connections. I am not using the Yamaha parts catalog/service manual. Can you tell? Lol. I’m new to this and...
  7. Y

    2005 Yamaha Trim Motor Replacement

    Thank you! So if I take the cowling off I will see that section you’re showing in the forward/front/bow facing section of the motor?
  8. Y

    2005 Yamaha Trim Motor Replacement

    Yes. It looks like the picture you posted was removed.
  9. Y

    2005 Yamaha Trim Motor Replacement

    Here is a picture of what my 225 looks like. You will see the layout is different than the 250 shown in the video above.
  10. Y

    2005 Yamaha Trim Motor Replacement

    Hello, I am trying to replace my trim motor on my 2005 225 4-stroke Yamaha. I watched the below video and it looked like an easy task; however, the motor he was working on was a 250 2005 and apparently the exhaust manifold layout is different than the 225. Does anyone know, have pictures, or a...
See more
Back
Top