Logo
FULL SITE MENU

Recent content by YngwieL

  1. Y

    Figuring out Cubic inches 1989 Evinrude 90 HP (E90TLCEM)

    Was tryin to figure out how they calculate cubic inches in my 1989 Evinrude 90HP.. and in the Manual I have, it states the Stroke is 2.858 / Bore Size is 3.50 / 4 Cylinders.. well when I put that in a calculator, its stating that the Cubic inches are 109.99 (110) but in the manual it states its...
  2. Y

    Turning down a crankshaft and bearings

    If you turn down a crankshaft say .010, is it even possible to get the rod bearings oversized? Tore my 1989 Evinrude 90HP apart finally today, and an pretty sure I can get it bored out .030 and get a rebuild kit for it.. but the rod bearings were trashed on the #3 cylinder piston.. looks like it...
  3. Y

    Using a 1989 Evinrude 90HP regulator/rectifier on a 1987 Evinrude 90HP

    As I mentioned in a older post, Motors I'm referencing are: 1987 Evinrude 90HP E90TLCUR and a 1989 Evinrude 90HP E90TLCEM - both have the tilt / trim on both motors, so I am the luck one that uses the $$$ regulator/rectifier Anyways, I disconnected the wire that's attached to the gray wire...
  4. Y

    Test Wheel for a 1989 Evinrude 90 HP E90TLCUR

    Would anybody happen to know what Model Number the Test Wheel is for my 1989 Evinrude 90HP - Model# E90TLCUR - Serial#R 1503738 I've tried look, but nobody selling them really explain what they fit, just show a casted part# number on the test wheel.
See more
Back
Top