Logo

1988 200HP Johnson Top Crankshaft Bearing

Smoky Too

New member
I've been chasing a low rpm sneeze for weeks and have finally concluded that the top crank seal (and possibly the bottom one too) is leaking. There is a little play when jiggling the flywheel so I would like to have the bearing on hand but cannot find a valid part number for just the bearing. P/N 5000574/0396668 is the top cover assembly at ~$520 so I'm not compelled to take that route (unless it goes really ugly!!)

The bottom bearing is P/N 0390641/0320499 so I'm hoping the top bearing is the same or that someone here has already figured this out for me.

BTW the model number for the motor is J200TXCCR
 
<p>Sneeze at low rpm on a looper is almost always lean, and a leaking top seal is the usual suspect, so your thinking is on the right track. Before you buy anything though I would pressure test the block. Plug the intake and the exhaust, pump it up to about 5 psi and watch the gauge. If it bleeds down, a little soapy water on the top seal and around the intake flange will show you where it is going.</p><p><br></p><p>Now the play. Was that radial play with the flywheel still bolted on, or did you have it off? If that nut was ever run loose the flywheel can fret on the taper and you get movement that feels like a bearing but is really a damaged crank nose. Look at the taper for shiny fretting marks before you blame the bearing. That one catches a lot of people.</p><p><br></p><p>On these loopers I believe the upper main is a ball bearing carried in the top half of the crankcase, and the seal sits above it in that cover under the flywheel. If that is right then the 5000574 you found is cover plus seal, not the bearing at all, which would explain why you cannot find a number for just the bearing. Worth confirming on the parts diagram before you spend.</p><p><br></p><p>I do not have the top bearing number memorized and I am not going to guess at one. Give a dealer the J200TXCCR and ask them to pull the crankshaft page, then compare the upper and lower numbers yourself. My recollection is they are not the same part, but do not take my word for it.</p><p><br></p><p>One more thing. If it has been sneezing for weeks while you kept running it, check the upper bearing bore in the block for galling once you are in there. A bearing that has been spinning will pound that bore and then a fresh bearing will not fix it. And make sure the idle air bleeds are clean, a plugged bleed will sneeze exactly like a bad seal and cost you nothing to check. thanks</p>
 
Thanks for the reply !
Idle air bleeds ? I'm not familiar with those.
I'm planning to tear into it as soon as the wind stops blowing and hoping for the best. Once
i have the old parts in hand it should eliminate the guess work and I'll repost with an update.
 
Back
Top