Logo
FULL SITE MENU

Search results

  1. J

    LM 318 BW coolant hoses

    I'm in need of some direction on where to find replacement formed hoses or what hoses have you used that are close to original. part # ? Seems from what i have searched that this is a issue on replacing on chryslers no part numbers on hoses unlike Crusader.
  2. J

    M460 spec info needed

    Looking at a potential vessel and need the following spec's on this model Chrysler M460 (Ford) 1. Torque chart with RPM 2. HP rating @RPM 3. Hydraulic or solid lifters 4 Fuel consumption per hour Also any feedback on these motors good and bad.
  3. J

    454 rebuild info needed

    I'm looking for correct info for my Gen 4 454 model 350 FWC 1171hrs. (dropped valve on #4) Casting # of the heads that make the 350 hp not the 330 hp
  4. J

    1979 270 Crusader decals....

    Steve, The border and the Crusader are black and the back ground is chrome. Tom
  5. J

    Crusader Model 1996 350 Identification... help please

    Re: Crusader Model 350 Identification... help please Here is location of ID plates,that red label you see in other photo is the firing order label.
  6. J

    1979 270 Crusader decals....

    Steve, These should help.
  7. J

    timing pointer help

    Eddie, This should be what you need.
  8. J

    454 's starting problems

    Looking for feedback on this issue. Port engine and Starbd.engine will not start unless i have P & S battery switches in the All positions. After starting i can switch to normal P#1 and S#2 but if i turn engines off at key i then get nothing. When they run both run fine but i don't want to leave...
  9. J

    454 Engine Temp

    "Looking for IR temp data of o "Looking for IR temp data of oil filter and trans. case temp.or does anyone have Crusader spec's of what they recommended what the oil temp.should be in the engine itself. Thanks Dave for telling me about starting new discussion,wasn't paying attention of where i...
  10. J

    Heat Exchanger Hose

    "Captins, Looking for feedbac "Captins, Looking for feedback on using a formed hose from Crusader vs ShieldsflexII between circulating pump to hex the 1 7/8" hose. I'm replacing all the other hoses with ShieldflexII. Also any info on antifreeze on what spec's to look for."
Back
Top