Logo
FULL SITE MENU

Search results

  1. R

    Air/fuel adjustment

    Can anyone tell me from this pic where's the mixture screw is? The top screw on upper left is for choke the screw under i thought was for idle adjustment.
  2. R

    2011Merc 20hp Carburetor removal

    Hello boaters, im wanting to remove the carb off 2011 20hp merc. I believe its only 2 bolts holding it in place. Removed one but, cant get get a wrench to the second bolt. Anybody have an idea? I've tried removing the flywheel doesnt budge. Any tips would be appreciated.
  3. R

    Fuel regulator

    My 20hp mercury dies after running for about 10secs and also smokes a little bit. Thers also some fuel that gives off a rainbow effect on the water. Took off the regulator and blew through one end and air flows through but,not the opposite side, it appears to be fine. Just cannot understand why...
  4. R

    Motor stops running

    Hello, all. I have an merc 20hp outboard and is dying on me. Went trolling yesterday and had a hell of a time keeping in running. It would shut off at full throttle after about 45sec. It would die when i would troll 1.5mph.ran fine a week ago. Fuel filter looks good.
  5. R

    Rubber piece stuck in impeller

    Hello, boat lovers,Took my boat out yesterday and noticed no water coming out of it. Brought it home and blew the outlet out. It worked after that. There must be a small piece of rubber from the old impeller in there somewhere. Any suggestions on getting it out?
  6. R

    Kill switch

    Can i use this seadog universal kill switch on my 2011 20hp mercury o/b? The orginal has only 2-wire switch.
  7. R

    Oil leak

    I have a mercury 20hp outboard. Changed the oil and filter and noticed over a few days it seems to be leaking from the lower end. Anybody know where it can be coming from? It wasnt leaking before the oil change. Everything is tight, its not leaking from oil plug or filter.
  8. R

    Mercury 20hp priming

    Hello all, I'm having an issue with priming. I was getting my 13' aluminum ready and went to prime and the bulb collapses. Replaced the bulb and cant get any fuel to the prime bulb on the engine. All my lines look good. Any ideas?
Back
Top