Logo
FULL SITE MENU

Search results

  1. H

    Removing tilt/trim assembly

    Since you have a metal transom you can unbolt one side of tilt bracket instead of hoisting the whole engine off the boat. Loosen big 32MM tilt shaft nuts on both sides, and use dead blow to hammer one side tilt bracket to spread open. It might chaff the transom but it won't crack or chip...
  2. H

    2006 BF150 Water in oil

    A hole in the head the engine will run like crap or not at all if you have a bad head and you will defialty get water on a plug, you can even see the water shooting out the spark plug hole when turning it over. When you pulled each spark plug did you see a droplet of water on any that would...
  3. H

    2006 BF150 Water in oil

    Your compression reading are too high to have bad head. the rust colored spark plug thru me off. Do you have actual rust on the plug or is the ceramic a rust color? Additives might cause the color change. I had a bad chain case gasket below the thermosates that will leak water into the...
  4. H

    2006 BF150 Water in oil

    I have had the milkey oil on four BF150s couple 2004 275 hours and couple 2007 engines 800 hours. The years make the engines differant, differant chain cases and wiring harnesses. Getting the pullyweel off without the 55MM socket holder is bit of a challange since the crank bolt holding it is...
View older results
Back
Top