Logo
FULL SITE MENU

Search results

  1. P

    97 Johnson 130 in SLOW/Limp mode

    Understand, just looking for guidance as to where to start. Thanks
  2. P

    97 Johnson 130 in SLOW/Limp mode

    Well I feel the tell-tale stream and at best it gets luke warm. I don't have a temp gauge there is a light though on the dash and that does not seem to come on.
  3. P

    97 Johnson 130 in SLOW/Limp mode

    120 per cylinder on compression, new impeller, pumps water fine. You rev motor in neutral or in gear and around 2k rpm it engine pulses. When I looked that up it says it is in SLOW mode. One video I found the engine was doing the same thing as mine when revved and they said it was trigger...
  4. P

    97 Johnson 130 in SLOW/Limp mode

    Hey everyone, I have a Johnson 130hp that is in slow mode. Compression is good. Fuel delivery is good. How do I tell what the issue is? I have seen that it could be power pack, stator, thermostats, or trigger. Is there a way to isolate and figure out what is causing it? Thanks
  5. P

    97 Johnson 130 bogging after 2k rpm

    Compression - Around 120 on each cylinder Spark - Not sure if it jumps 3/8 but put spark plug against head and have spark on all cylinders. Wires - I will have to check on this Red lever on primer is in the correct location. I will have to try the push key method. Do you think carbs can play...
  6. P

    97 Johnson 130 bogging after 2k rpm

    Hey Everyone, So I recently purchased a 17ft Seaswirl with a Johnson 130 on it. Motor idles fine but when increasing throttle past 2k rpm it seems to rev sporadically and bog down even in neutral. I have deleted the VRO and have a Johnson fuel pump on it. It also has a primer solenoid and I...
  7. P

    97 Johnson 130 Tilt issue

    yes, i recently got the boat but I believe it was in salt water.
  8. P

    97 Johnson 130 Tilt issue

    Hey everyone, When I tilt the motor up or down the swivel bracket that the pump and tilt tube sits on, on the transom. It goes up an down fine but makes that noise. Once it gets down to the trim rams that part seems smooth. I do not see any zerk fittings anywhere to grease that swivel...
View older results
Back
Top