Logo
FULL SITE MENU

Search results

  1. S

    Tilt trim relay bracket

    Looking at the picture I cant really tell if the bracket is melted.You sure thats not the sealer the factory puts on.As far as the relays arcing check your ground wire and make sure its clean and tight.
  2. S

    Shift position for gearcase removal 1993 200HP Johnson

    In neutral if its a Johnson or Evinrude.
  3. S

    1977 evinrude 9.9 cooling question

    Should be water comming out whenever running.Is there water comming out the hole in the rear of the exhaust housing.
  4. S

    Air is leaking from exhaust during leak test on lower. What seals are broken?

    yes you can.
  5. S

    Air is leaking from exhaust during leak test on lower. What seals are broken?

    bearing carrier o ring,replace the propshaft seals also while you have it apart.
  6. S

    U S Marine 4hp

    yes it does,you have to remove the lower unit to get to it.look at the parts breakdown on this site for assistance.
  7. S

    Please Help!!!

    Try Tim's Outboard in Hackensack Mn. 218-682-2331.Great people with lots of used Johnson and Evijrude parts.
  8. S

    115 L6 Mariner Lower Unit

    pickup for the speedometer,if you have a pitot tube on the transom you dont need it.
  9. S

    Leaking Fuel From Air Intake Gasket

    What would cause it then.We quit running vro equipped engines out of fuel before putting them into winter storage and didnt have any problems after that.
  10. S

    Leaking Fuel From Air Intake Gasket

    I cant explain it racerone but I have seen it on several engines.When I pulled them out of winter storage and tried starting they wouldnt start.Remove the float bowl drain plugs and oil runs out.
  11. S

    Leaking Fuel From Air Intake Gasket

    Fills the float bowls full of two stroke oil if you unhook the fuel hose,have even had that happen when winterizing using the valve on the primer.
  12. S

    Leaking Fuel From Air Intake Gasket

    Unhook your fuel hose and run the motor out of fuel before you take it out of the water.Problem solved,you can do this on motors with a regular fuel pump but not on vro equipped engines.
  13. S

    15 hp only runs on Choke

    I would say that you have possibly two problems,plugged main jet and a bad float or inlet needle.Carb needs to come off for inspection and repair.
  14. S

    Merc 70.

    Is it possible that you are getting water through the cowling or hood gasket when you slowdown.That could possibly cause the plug wire/spark plug to get wet and short out to ground.After you sit for awhile the engine heat dries it out and it runs could again.
  15. S

    50 HP VRO to Mix Fuel pump

    You said you replaced the fuel line and primer bulb,stupid question but is the arrow on the bulb pointing towards the engine.Was the fuel pump and hose quality parts or Amazon China junk?Try priming the engine then start it,when it dies remove the drain plugs on the float bowls and see if any...
  16. S

    50 HP VRO to Mix Fuel pump

    Did you get your fuel hoses put on backwards by mistake?If I remember right the fuel in from the tank goes on the black plastic cap and fuel out to the carbs goes on the other hose barb.
  17. S

    Water pump adhesive

    If you mean the oring in the water pump housing try installing the impeller into the housing by turning it counter clockwise.Then use some grease to hold the oring in the housing.
  18. S

    the

    Fuel inlet needle and seat could be bad or the the float could heavy or stuck.
  19. S

    Mariner 30 hp long shaft two stroke telltale

    It does not appear to have one on that engine.
  20. S

    Mariner 30 hp long shaft two stroke telltale

    Could you please post the model and serial number.Your motor should have one,could be plugged with silt.
Back
Top