Logo
FULL SITE MENU

Search results

  1. S

    No Spark

    Easy things first,unhook your kill circuit,then check for spark.Is your starter cranking the engine fast enough,possibly try pulling your spark plugs out and crank it over to see if you got spark.Unhook your rectifier wires and check for spark.Take your ohmmeter and check resistance on the...
  2. S

    1999 evinrude shift lever

    Did you try Tim's Outboard,Hackensack,Mn.Lots of used parts,great people.218-682-2331
  3. S

    Mariner 30A belching gas out of spark plug holes

    Gotta be a stuck float or a ruptured fuel pump diaphragm.
  4. S

    Tilt and trim questions. 1984 edson intruder

    Yes,tilt the sterndrive all the way down,then control the trim with the trim switch.Replaced quite a few drive knuckles because the operator did'nt have the drive all the way down.
  5. S

    40 hp stalls

    You did'nt say what your running for a fuel tank,I assume it's a portable tank.Take your cap loose and see if it will run(venting problem).Also check your fuel line connector at the motor,may have a bad oring and it's sucking air instead of fuel.Don't forget the basics,spark and compression.
  6. S

    9.9 1993 no spark

    Fot the stator,blk/yel to grnd 3200-3800 ohms,blk/wht to grnd 225-300 ohms.For the trigger brn/yellow to brn/wht 750-1400 ohms.Disconnect your your kill circuit wire to see if you get spark.
  7. S

    1986 Evinrude 15 hp Fuel supply issue

    60 psi is pretty low numbers for compression.
  8. S

    1986 Mercury 135hp 2L V6 throttle and shift cable tuning

    If you can shift it into gear with the cables unhooked then your shift cable is out of adjustment,if you cant then theres a good chance your shift shaft and shift linkage are not aligned right.
View older results
Back
Top