Logo
FULL SITE MENU

Search results

  1. A

    1975 Mallory Distributor YL520CV

    will look into that,, turns out that Advanced Distributors doesn't want to sell springs, they want to have me send them the Dist. and they will rebuild it $200 - $300.
  2. A

    1975 Mallory Distributor YL520CV

    According to Advanced Distributors " no one makes Mallory springs"
  3. A

    1975 Mallory Distributor YL520CV

    Will send them a E-Mail, Thanks,
  4. A

    1975 Mallory Distributor YL520CV

    Wausaukee, Wisconsin, That's about 60 miles north of Green Bay or 200 miles north of Milwaukee
  5. A

    Mallory Distributor cap Firing order

    I purchased a crab type distributor cap for a YL-520-CV and the firing order molded on the cap is, reading clockwise 12736845 with the coil wire coming out between 2 and 7. Any one know this firing order, I am baffled.
  6. A

    1975 Mallory Distributor YL520CV

    Looking to replace the advance springs, Part # 313149, and 313150. Can not find the Blue 313150. Any help would be thankful for.
  7. A

    Bilge pump

  8. A

    Bilge pump

    You are right, was in a hurry, This ones how it should have been. Thank You again
  9. A

    Bilge pump

    Will this wiring sematic give me trouble if the SPST ( with indicator light) and the Auto float switch were turned on at the same time?? Wondering because of the use of the two battery's. Picture is included. Thank You ArtK
  10. A

    Tachometer reading off

    Yesterday while fishing all of a sudden when starting my 90hp mercury on my 1995 Tracker Pro 18 the tach. started to read 4000 as zero and pinned the needle at 6500 plus at WOT instead of the normal 0 to 4500 ish. Any thoughts would be helpful Thank You Art
  11. A

    Help in finding

    Dandy Haven Marina, has a new still in the bag, $65.00 plus shipping. Thanks ever so much Art Koester
  12. A

    Help in finding

    Will start calling,,,, Thank You !!!!
  13. A

    Help in finding

    Looking for a bearing carrier for a 1968 Mercury 20 HP serial # 2436661 Carrier Part # 33402A1--- 33402A4 -- or 33402T4 . Have searched internet, and E-Bay Thank You for any input Art K
  14. A

    OMC 1975 stringer engine

    Replacing the Chevy 307 with a early 350. any one know what initial timing should be and what the advance curve should look like. Using the original Mallory YL624JY but the springs are old and rusty. Also would like to know what the WOT should be. Thank You.
  15. A

    1975 OMC Slick Craft stringers

    The engine mounts were fastened to the stringers with 3/8" x3" lag bolts, during rebuilding the holes are now filled with epoxy. Can I pilot drill and use lag bolts, or is the epoxy to brittle for that, or drill out about 1/2" and epoxy 3/8" studs into the stringers and use nuts to mount, or...
  16. A

    OMC 1975 stringer electric

    I'm inspecting the drive from top to bottom and want to flush the lower drive section what would be best to use? I need to replace the two vertical shafts in the upper so that is completely apart. Thanks in advance
Back
Top