Logo
FULL SITE MENU

Search results

  1. B

    50TLR smokey

    How smokey should a 2008 50TLR be? Just had a carb rebuild and all mixture screws are turned 2 rotations out. The oil system seems to be functioning normally but it seems like a lot of smoke out the relief port, more than I would have imagined. It seems to stay steady even after it warms up. Any...
  2. B

    Interfacing with YDIS or other

    Hoping one of you Yama wizards can help me out. Trying to pull hours off of 2012 F115XA that only has Yamaha Tach and Speedo. Under fuse panel has an almost flat in-line 3-pin connector (W/B, B, R/B) for diagnosis instead of the square grey triangle oriented pin setup. Any ideas on how to pull...
  3. B

    Showa Trim/Tilt compatibility

    Can anyone confirm the Showa pumps are the same model across 90-225hp? Saw this somewhere and was wondering. This is the same pump as Yamaha just a different mounting style on the bottom for Honda. Thanks
  4. B

    '97 Johnson 150, primer ball flattening changed EVERYTHING

    Have a J150EXERA on a 17 whaler, I believe its a 97? I've read most the threads about flat primer balls. I'm Inheriting this boat from a previous mechanic that had the the same symptoms and threw just about every part at this thing in order to get it to run right. Ive gone through it all and...
  5. B

    impeller housing question 115 EFI

    Did a re-seal of lower unit and new impeller etc. It dawned on me a day later that I forgot the darn 'face seal' (part #861415) on top of the water-pump housing that goes around the shaft and sits do, is this crucial for function at all? I was under the impression it's just a 'dust seal' so to...
  6. B

    96 MCM 3.0LX Won't Start, Tried everything except ______ !? (Starts off Remote Switch)

    I usually don't get perplexed but.. New Starter, New slave solenoid, Tried a new key switch which didn't change anything, voltage and grounds all good on everything I have checked, battery, block ground etc. Voltage at key, with key-on at solenoid, at starter, at starter solenoid..Neutral safety...
  7. B

    05’ GM 3.0 Alpha one intake manifold stud thread

    Anyone know the thread/pitch of the 4 studs that hold TKS carb onto the intake manifold? I’m guessing it’s 5/16? As I only have mostly metric stuff. Trying to replace nuts that were misplaced, Cannot find a factory nut or part info anywhere. Any help appreciated!
Back
Top