Logo
FULL SITE MENU

Search results

  1. D

    BF50 warning buzzer

    Getting an intermittent buzzer when throttling up much past idle, green oil pressure light comes on, but if I try and continue throttling up the motor will shut itself down. It does crank back up but doesn’t want to go much past idle before that alarm goes off. I was thinking trim angle sensor...
  2. D

    BF50 warning beep

    Noticed this for the first time today, beeps with a pause in between and it only happened when running full throttle, when I brought it down to idle it stopped immediately. Couldn’t tell if one of the lights was on as the the plastic over them is weathered but my son said he thought it was the...
  3. D

    BF50 cooling issue

    Motor was running fine a few weeks ago. Put in a drum after oil and lower unit oil changes to run for a bit and it stopped peeing. Changed out the entire water pump, fired it up and nothing… waited a couple minutes and still nothing. Started to see a little smoke coming from the opening where...
  4. D

    BF50 more issues

    Motor ran fine last time out a couple of weeks ago. We had had an issue when we had just gotten it with the no. 1 cylinder not firing but saw what appeared to be a ground wire that appeared to be out of place and reseated it and it has ran fine since. Well after an oil change today I started...
  5. D

    BF50 still having a peeing problem

    Everything is finally running nice, we were peeing when we had muffs on it yesterday. We went out for a test run today and it was peeing when we started but stopped probably 5-10 minutes into our run. I could see it dripping occasionally and sometimes not at all as we cruised back. When I got...
  6. D

    More BF50 issues

    Got it out on the water for the first time this morning after replacing impeller and thermostat. Was peeing when we started but after 10 or so minutes I looked back and it had stopped. We fished for an hour or so and when we cranked back up it started peeing again a little bit, gradually...
  7. D

    Help!!! Thermostat replacement BF50

    So one of the bolts for the top part that covers the gasket and thermostat just broke off when I was trying to remove it. Any suggestions on how to get this out? I tried to grab it with a pair of vice grips but it wouldn’t budge.
  8. D

    Shift rod connection BF50

    I am trying to install a new impeller kit and am having issues disconnecting the shift rods. I am fairly mechanically inclined but am totally new to the outboard world. I have loosened the lock but to the bottom and turned the bigger nut clockwise but am not getting far enough up to disconnect...
Back
Top