Logo
FULL SITE MENU

Search results

  1. M

    new install 5.7 volvo

    I put it in all 4 corners but needs it in the round part of cover right on the middle at botton
  2. M

    new install 5.7 volvo

    Hey to all helping me with my engine. So I got everything working pretty good, but now i have a new problem. I'm getting one drop of oil about every 10 seconds at the bottom of the timing cover and oil pan. It has the rubber one piece seal. The plan is to lift the engine, pull the pan...
  3. M

    new engine install

    Do you know if this chart applies to volvo penta temp sender
  4. M

    new engine install

    Also there is no choke. this is a fuel injected engine.
  5. M

    new engine install

    the volvo fuel pumps have a known issue with the paint. Ethonol fuel breaks the paint down and it flakes. Volvo has a bulletin out on it. Man cave repairs this problem or supplies parts for the repair.
  6. M

    new engine install

    I do not know if the ect is bad. But i read it should be done as a regular maintaince , not sure about that. how could i test it. . Also i just test pump with gauge and when i increased the RPM it would drop from 51 psi to 46 47 psi . The screan is clean on the regulator but the...
  7. M

    new engine install

    Yes, I plan on replacing the ect . But I just ordered the seals for the fuel pump assembly. I'm going to clean out everything in the fuel system before just replacing it. I was getting good readings on low and high pumps but under load, the high-pressure pump would drop pressure. I believe...
  8. M

    new engine install

    250 for OEM crankshaft sensor, cam sensor is 300 . Need to check fuel pressure to rule those out. had a car once that would kill once warm , it was the camshaft sensor. I'm pretty good at guessing. :)
  9. M

    new engine install

    cam and crank sensors. Its fine after it sat . started right up. once warm acts up
  10. M

    new engine install

    I Im wondering about cam and crank sensors .
  11. M

    new engine install

    So update . rapped up hooking everything up, including gas line. It fired right up. and ran great. Took a minute to get oil into lifters but it sounds great. So i warmed it up and shut it down. inspected for leaks . none. Tried to restart and it almost started. Right back to...
  12. M

    new engine install

    I did read that. to unlock the distributer. I was going to take it to my dealer to have it done. Is the distributer fine where it's at. Could i try to start to the engine. I think im ready
  13. M

    new engine install

    Distributer is sitting down in oil pump slot . its lined up but if you look at the other pic the screw to cap is right on the manifold . If it needs to be moved for timing that way it wont work. Plug also looks the same with wiring harness
  14. M

    new engine install

    nope
  15. M

    new engine install

  16. M

    new engine install

    I wondering if this mark on the manifold is for where to point the rotor for 1
  17. M

    new engine install

    I'm good to go except for the distributor, and also, my alternator red wire is broken. The end link must have rotted off, and it is too short to fix. Can I add a short piece?
  18. M

    new engine install

    yes all grounds are hooked up there
  19. M

    new engine install

    all my cables are yellow from the battery . Whats the bat cable? not sure i have that
  20. M

    new engine install

    pics won't post
Back
Top