Logo
FULL SITE MENU

Search results

  1. P

    1997 Johnson 130 V4 Looper Idle

    I am looking for some guidance on increasing the idle a little on my Johnson 130. It is currently idling very low so much so that when I put it in gear it will die. If I put it in gear quick and idle up fast boat performs fine. I just need it bumped a little on the rpm when in neutral. I...
  2. P

    97 Johnson 130 not idling hard to start now

    Hey everyone. Quite a newbie here. The motor was idling ok but was low idle. Tried to adjust what I thought was the idle screw but I think it was a timing screw. Now it won’t start and if it does start it conks out. I know I messed up but how can I fix it. Thanks in advance. Pic attached
  3. P

    Prop for 1997 Johnson 130HP

    It's a 17' bowrider.
  4. P

    Prop for 1997 Johnson 130HP

    Numbers are worn off, can't make any of them out. It is a V4
  5. P

    Prop for 1997 Johnson 130HP

    Good morning, I am looking to replace my prop on my Johnson 130. Can't seem to get any numbers off the current prop. What does everyone recommend for a replacement? I have read that it should be 14 1/4 x 17 15 spline but not sure if that is correct? Thanks in advance...
  6. P

    1997 Johnson 130 throttle runup

    Hey everyone, I have an 1997 Johnson 130. Idles beautifully. When I rev past 2500 the throttle takes off to full throttle even though butterflies do not move more open and linkage stays the same. I noticed as it does that I get some fire out of the carbs. Is it doing this because it is...
  7. P

    Spark Plug Wires

    Thank you!
  8. P

    Spark Plug Wires

    Does anyone know where to purchase good spark plug wires for a 1997 Johnson 130. I bought some on amazon but they were too thick and did not fit correctly. Thank you
  9. P

    97 Johnson 130 bogging after 2k rpm

    Ended replacing the power pack and that fixed the issue. Thanks for all the help!
  10. P

    97 Johnson 130 in SLOW/Limp mode

    Ended replacing the power pack and that fixed the issue. Thanks for all the help!
  11. P

    97 Johnson 130 in SLOW/Limp mode

    Ok replaced 2 coil packs, I believe running on all cylinders but still in SLOW mode when you rev above 3k. Motor acts like it hit rev limiter. Is there a way to test power pack before buying one of those? What should I test next, trying not to replace every part just the bad ones. Thanks
  12. P

    97 Johnson 130 Tilt issue

    How do I go about cleaning it? Below circled in red is the part that is pivoting and clicking. Thanks H
  13. P

    97 Johnson 130 in SLOW/Limp mode

    OK motor is not overheating but seems to be running on only 2 cylinders. Tested the coil packs and 2 seem bad so I am going to replace those and see. Is there anyway to replace the boots on the coil wires without replacing the whole power pack? Tried looking online but can't find replacement...
  14. P

    97 Johnson 130 in SLOW/Limp mode

    Its a 1997 Seaswirl bow rider
  15. P

    97 Johnson 130 in SLOW/Limp mode

    Should there be a separate warning horn from the regular navigation horn?
  16. P

    97 Johnson 130 in SLOW/Limp mode

    1) No I hear no horn. Not sure if it even has one 2) My temp switches have no barrel disconnects. Not sure if previous person messed with these but they are butt connected. Should I just cut and re do connections? 3) I will try this. 4) I just ordered new thermostats and will be putting them...
  17. P

    97 Johnson 130 in SLOW/Limp mode

    Pulse limiter is there. https://bayareapowersports.com/johnson-evinrude-outboard-fuel-pump-20-235-hp-438559-385784-433390-395712?srsltid=AfmBOor-aTAh5EN1jcfshf60UIwBVoByFY7CLnPOekTGDhpm1dN207LV
  18. P

    97 Johnson 130 in SLOW/Limp mode

    I believe its rated all the way up to 250hp V6. Plus this symptom was happening with the VRO still on it.
  19. P

    97 Johnson 130 in SLOW/Limp mode

    Part # 0438559
  20. P

    97 Johnson 130 in SLOW/Limp mode

    VRO delete, Johnson fuel pump and premix
Back
Top