Logo
FULL SITE MENU

Search results

  1. R

    Multiple Starters

    The hull and all bulkhead fittings have been checked and do not leak. Water can get into the bilge by rainwater and wash down water only. I have run the pumps any time I see any water in the bilge. The float switch works very well and removes the water down to perhaps a cup or 2. I run the...
  2. R

    Multiple Starters

    Yes, I am pulling the motor to install a new plate and a new starter. Thanks, makomark and jimn for helping me out. Jim
  3. R

    Multiple Starters

    Are you aware of any different starters available on the market that might be designed to better deal with this issue? I have been using high quality Sierra starters for marine use. They have a very tight nosecone area that tries to cut down the exposure to water intrusion. Any that have...
  4. R

    Multiple Starters

    Your suggestion for a fan is a great idea. I will get something to address that. Yes, I have a factory part # and there are several listed on eBay They look like flat steel to block off the front of the flywheel to bell housing area Jim
  5. R

    Multiple Starters

    Yes, Salt Water. Yes I use shore power. I use a high amperage drop light in the bilge to try to control condensation. Maybe I should consider a fan. Good idea. I spray WD-40 or a heavy spray lithium grease down a 1/8 in ID hose while engaging the starter, in order to move the bendix in and...
  6. R

    Multiple Starters

    The starters have been lubed prior to installation. The last starter installed had a hole drilled in the nose cone and a rubber hose glued into it so that I could spray the shaft-bendix with lube after each outing, lasted 6 mos. The boat is in a slip year-round. Bilge auto switch works perfect...
  7. R

    Multiple Starters

    I have had to replace 3 starters in 1 year in my 2000 Seaswirl Striper. Penta STX outdrive 5.7L V8 Chev Vortec engine. The starters all have rusted between the bendix and the shaft. They will spin but not engage the flywheel. It appears that the cover between the engine and the bell housing is...
  8. R

    Volvo Penta 225F Sterndrive Starter Motor Failure

    I too have had to replace multiple starters due to rust. Mine seize between the starter bendix and the shaft. AND i keep the bilge as dry as possible. Check to see if there is a cover between the engine and the bell housing that will keep most of the water from splashing onto the starter. My...
Back
Top