Tony Norton
New member
Hi All,
I have recently been asked by a relative to have a look at an hours meter that is not working. This is NOT the much trumpeted LCD display version, but pre-dates that in that it has an electro-mechanical counter. I need to remove the PCB that controls everything, but in order to do so I need to remove the 5 off male spade terminals that take the input from the boat power nad the alternator. Problem is I can't get the damn things out of the housing. There are 4 terminals plus a single one, presumably GND. I cannot work out how to release the tabs that hold the terminals in place.
I could supply a picture, but I can't work out how to "insert image".
Thanks in advance for any help you can offer.
Tony Norton
I have recently been asked by a relative to have a look at an hours meter that is not working. This is NOT the much trumpeted LCD display version, but pre-dates that in that it has an electro-mechanical counter. I need to remove the PCB that controls everything, but in order to do so I need to remove the 5 off male spade terminals that take the input from the boat power nad the alternator. Problem is I can't get the damn things out of the housing. There are 4 terminals plus a single one, presumably GND. I cannot work out how to release the tabs that hold the terminals in place.
I could supply a picture, but I can't work out how to "insert image".
Thanks in advance for any help you can offer.
Tony Norton