Quicksilver Marine Parts Catalog
- Contents
- Pre-1988 Mariner
- Mercury & Mariner
- Carburetor Kits
- Fuel Pump Repair Kits
- Ignition Keys
- Ignition Parts (2-Stroke)
- Ignition Parts (4-Stroke)
- Lower Unit Gearcase Seal
- Pistons
- Oil Filters
- Powerhead Gasket Sets
- Rod Main Bearings
- Solenoid Relay (2-Stroke)
- Solenoid Relay (4-Stroke)
- Spark Plugs (2-Stroke)
- Spark Plugs (4-Stroke)
- Stators
- Thermostat Kits
- Water Pump Parts (2-Stroke)
- Water Pump Parts (4-Stroke)
- Mercruiser
- Engine Parts
- View All »
- Alternators
- Camshafts, Bearings, Lifters & Push Rods
- Carburetors
- Connecting Rod Bearings
- Crankshaft Bearings
- Distributor Assembly & Components
- Distributor Gears
- ECMs, Coils, Wires & Spark Plugs
- Engine Couplers
- Engine Gaskets
- Exhaust Manifolds & Elbows
- Flame Arrestors
- Fuel Coolers
- Fuel Injection Components
- Fuel Pumps & Filters
- Ignition Tune-up Kits
- Intake & Exhaust Valves
- Oil Coolers
- Oil Pumps & Components
- Piston Rings
- Pistons
- Rocker Arms & Hardware
- Starter Parts
- Starters & Solenoids
- Thermostats, Housings & Covers
- Timing Chains & Gears
- Valve Caps, Springs & Keepers
- V-Belts & Serpentine Belts
- Water Hoses—Engine Supply
- Water Hoses—Exhaust Cooling
- View All »
- Transom & Drive Parts
- View All »
- Bearing Carriers
- Bellows
- Drive Shaft Housing & Sterndrive Units
- Drive Shaft Housing Bearings
- Drive Shaft Housing Gears
- Gear Case Bearings
- Gear Case Gears
- Gear Case Seals
- Gear Case Shafts
- Gear Case Shims
- Gimbal Bearings
- Installation Gaskets
- Trim Cylinders
- Trim Cylinder Hardware
- Trim Cylinder Hoses
- Universal Joints (U-Joints)
- Water Pump Impellers & Kits
- View All »
- Engine Parts
- Page Numbers
ELECTRICAL
EXTENSION HARNESS - 14 PIN
25 ft. harness (896537A24) with new 14 pin connector for the engine and
additional connectors that allow easy quick connect solutions to the rigging
process. Loose harness.
2006 and newer Non DTS Outboards from 25 Hp to 250 HP‑ 14 Pin Connectors
All MCM / MIE engines equiped with 14 pin connectors
30 ft. harness (896537A29) with new 14 pin connector for the engine and
additional connectors that allow easy quick connect solutions to the rigging
process. Loose harness.
2006 and newer Non DTS Outboards from 25 Hp to 250 HP‑ 14 Pin Connectors
All MCM / MIE engines equiped with 14 pin connectors
6 ft. (1.8 meter) data harness. Provides data link between DTS engine and
command module harness.
40 ft. harness (896537A40) with new 14 pin connector for the engine and
All 2005 and newer DTS engines (Verado/OptiMax/MCM) equipped with 14 pin
additional connectors that allow easy quick connect solutions to the rigging
connectors.
process. Loose harness.
2006 and newer Non DTS Outboards from 25 Hp to 250 HP‑ 14 Pin Connectors
10 ft. (3.0 meter) data harness. Provides data link between DTS engine and
All MCM / MIE engines equiped with 14 pin connectors
command module harness.
All 2005 and newer DTS engines (Verado/OptiMax/MCM) equipped with 14 pin
HARNESS - NON DTS 14 PIN- ANALOG GAUGE
connectors.
15 ft. (4.6 meter) data harness. Provides data link between DTS engine and
command module harness.
All 2005 and newer DTS engines (Verado/OptiMax/MCM) equipped with 14 pin
connectors.
20 ft. (6.1 meter) data harness. Provides data link between DTS engine and
command module harness.
All 2005 and newer DTS engines (Verado/OptiMax/MCM) equipped with 14 pin
connectors.
This harness will connect directly to the non DTS harness at the helm. It will allow
25 ft. (7.6 meter) data harness. Provides data link between DTS engine and
you to connect to analog gauges on the dash and allows the choke function to work
command module harness.
on the 8/9.9/15/20 FourStroke carbureted outboards with serial numbers beginning
with "0R". 5 ft long Used with 84‑896537__ harness
All 2005 and newer DTS engines (Verado/OptiMax/MCM) equipped with 14 pin
2006 and newer Non DTS Outboards from 25 Hp to 250 HP‑ 14 Pin Connectors
connectors.
All MCM / MIE engines equiped with 14 pin connectors
30 ft. (9.1 meter) data harness. Provides data link between DTS engine and
command module harness.
This harness will connect directly to the non DTS harness at the helm. It will allow
you to connect to analog gauges on the dash. 10 ft long Used with 84‑896537__
All 2005 and newer DTS engines (Verado/OptiMax/MCM) equipped with 14 pin
harness
connectors.
2006 and newer Non DTS Outboards from 25 Hp to 250 HP‑ 14 Pin Connectors
All MCM / MIE engines equiped with 14 pin connectors
40 ft. (12.21 meter) data harness. Provides data link between DTS engine and
command module harness.
This harness will connect directly to the non DTS harness at the helm. It will allow
All 2005 and newer DTS engines (Verado/OptiMax/MCM) equipped with 14 pin
you to connect to analog gauges on the dash. 15 ft long Used with 84‑896537__
connectors.
harness
2006 and newer Non DTS Outboards from 25 Hp to 250 HP‑ 14 Pin Connectors
All MCM / MIE engines equiped with 14 pin connectors
US Quicksilver Product Guide
255