Quicksilver Marine Parts Catalog
- Contents
- Pre-1988 Mariner
- Mercury & Mariner
- Carburetor Kits
- Fuel Pump Repair Kits
- Ignition Keys
- Ignition Parts (2-Stroke)
- Ignition Parts (4-Stroke)
- Lower Unit Gearcase Seal
- Pistons
- Oil Filters
- Powerhead Gasket Sets
- Rod Main Bearings
- Solenoid Relay (2-Stroke)
- Solenoid Relay (4-Stroke)
- Spark Plugs (2-Stroke)
- Spark Plugs (4-Stroke)
- Stators
- Thermostat Kits
- Water Pump Parts (2-Stroke)
- Water Pump Parts (4-Stroke)
- Mercruiser
- Engine Parts
- View All »
- Alternators
- Camshafts, Bearings, Lifters & Push Rods
- Carburetors
- Connecting Rod Bearings
- Crankshaft Bearings
- Distributor Assembly & Components
- Distributor Gears
- ECMs, Coils, Wires & Spark Plugs
- Engine Couplers
- Engine Gaskets
- Exhaust Manifolds & Elbows
- Flame Arrestors
- Fuel Coolers
- Fuel Injection Components
- Fuel Pumps & Filters
- Ignition Tune-up Kits
- Intake & Exhaust Valves
- Oil Coolers
- Oil Pumps & Components
- Piston Rings
- Pistons
- Rocker Arms & Hardware
- Starter Parts
- Starters & Solenoids
- Thermostats, Housings & Covers
- Timing Chains & Gears
- Valve Caps, Springs & Keepers
- V-Belts & Serpentine Belts
- Water Hoses—Engine Supply
- Water Hoses—Exhaust Cooling
- View All »
- Transom & Drive Parts
- View All »
- Bearing Carriers
- Bellows
- Drive Shaft Housing & Sterndrive Units
- Drive Shaft Housing Bearings
- Drive Shaft Housing Gears
- Gear Case Bearings
- Gear Case Gears
- Gear Case Seals
- Gear Case Shafts
- Gear Case Shims
- Gimbal Bearings
- Installation Gaskets
- Trim Cylinders
- Trim Cylinder Hardware
- Trim Cylinder Hoses
- Universal Joints (U-Joints)
- Water Pump Impellers & Kits
- View All »
- Engine Parts
- Page Numbers
ELECTRICAL
TRANSOM MOUNTED POWER TILT PANEL
POWER TRIM SWITCH KIT
Rocker switch style with 10 ft.(3.05 m) harness and 3 blade connector. Installation
Rocker switch style with 6 ft.(1.8 m) harness and bullet connectors. Provides tilt
requires power trim "Y" harness (58366A 2). Provides tilt control from the bow or
control from the outside of the boat when trailering and launching. "T" harness
transom location.
(included in kit) connects directly to trim pump with 3 pin Packard connector.
Fits Mercury/Mariner models equipped with remote mounted trim pump.
Fits MCM models with newer power trim having the 3 pin Packard connector.
POWER TRIM SWITCH KIT
WARNING SYSTEMS
WARNING HORN KIT
Rocker style switch with 10 ft. harness and bullet connectors. Can be surface
mounted or flush mounted. Provides tilt control from the bow or transom location.
Fits Mercury/Mariner models equipped with integral trim pump.
Kit includes the new style piezo horn used with 1986 and newer remote controls
and wiring harnesses.
Rocker switch style with 25 ft.(7.62 m) harness and bullet connectors. Can be
surface mounted or flush mounted. Provides tilt control from the bow or transom
Fits 2000 and newer Mercury/Mariner V‑6 outboards. Also fits MY2002 and newer
location.
525‑1200 Hp. Race Sterndrives.
Fits Mercury/Mariner models equipped with integral trim pump.
LIGHT - DASH MOUNTED - CATALYST MALFUNCTION
TRANSOM MOUNTED POWER TILT PANEL
Light will go on indicating that a malfunction has ocurred with your catalyst on your
engine. This means you will need to get your engine serviced soon. Works similar
Rocker switch style with 6 ft.(1.8 m) harness and bullet connectors. Provides tilt
to your check Engine light in your truck or car. (harness to be sold seperately)
control from the outside of the boat when trailering and launching. "T" harness
Harness numbers for single helms
(included in kit) connects directly to trim pump with traditional 3 blade connector.
(M0048049,8M0048054,8M0048055,8M0048056,8M0048057,
Fits MCM models with power trim having the traditional 3 blade connector.
8M0048058,8M0048059 )
Mercruiser products that are equipped with a catalyst
US Quicksilver Product Guide
261