Quicksilver Marine Parts Catalog
- Contents
- Pre-1988 Mariner
- Mercury & Mariner
- Carburetor Kits
- Fuel Pump Repair Kits
- Ignition Keys
- Ignition Parts (2-Stroke)
- Ignition Parts (4-Stroke)
- Lower Unit Gearcase Seal
- Pistons
- Oil Filters
- Powerhead Gasket Sets
- Rod Main Bearings
- Solenoid Relay (2-Stroke)
- Solenoid Relay (4-Stroke)
- Spark Plugs (2-Stroke)
- Spark Plugs (4-Stroke)
- Stators
- Thermostat Kits
- Water Pump Parts (2-Stroke)
- Water Pump Parts (4-Stroke)
- Mercruiser
- Engine Parts
- View All »
- Alternators
- Camshafts, Bearings, Lifters & Push Rods
- Carburetors
- Connecting Rod Bearings
- Crankshaft Bearings
- Distributor Assembly & Components
- Distributor Gears
- ECMs, Coils, Wires & Spark Plugs
- Engine Couplers
- Engine Gaskets
- Exhaust Manifolds & Elbows
- Flame Arrestors
- Fuel Coolers
- Fuel Injection Components
- Fuel Pumps & Filters
- Ignition Tune-up Kits
- Intake & Exhaust Valves
- Oil Coolers
- Oil Pumps & Components
- Piston Rings
- Pistons
- Rocker Arms & Hardware
- Starter Parts
- Starters & Solenoids
- Thermostats, Housings & Covers
- Timing Chains & Gears
- Valve Caps, Springs & Keepers
- V-Belts & Serpentine Belts
- Water Hoses—Engine Supply
- Water Hoses—Exhaust Cooling
- View All »
- Transom & Drive Parts
- View All »
- Bearing Carriers
- Bellows
- Drive Shaft Housing & Sterndrive Units
- Drive Shaft Housing Bearings
- Drive Shaft Housing Gears
- Gear Case Bearings
- Gear Case Gears
- Gear Case Seals
- Gear Case Shafts
- Gear Case Shims
- Gimbal Bearings
- Installation Gaskets
- Trim Cylinders
- Trim Cylinder Hardware
- Trim Cylinder Hoses
- Universal Joints (U-Joints)
- Water Pump Impellers & Kits
- View All »
- Engine Parts
- Page Numbers
ACCESSORY KITS FOR PLUS-SERIES ENGINES
INTERMEDIATE ELBOW KIT
RISER KIT
6 in. (152 mm) for standard cooling and dry joint exhaust manifolds.
Only required on sterndrive engines that have the exhaust going through the prop.
Fits 2004 and newer MCM V‑6 (s/n 0W310000 and up); 2002 and newer MCM V‑8
Fits MCM V‑6 with 2 piece exhaust manifolds and 3 in. (76 mm) risers ‑ s/n
(305, 350 & 377 cid) non‑EC engines (s/n 0M615000 and up) & MIE V‑8 (350 &
0W309999 and below
377 cid) non‑EC engines (s/n 0M390000 and up).
INTERMEDIATE ELBOW KIT
EXHAUST ELBOW/RISER KIT - 6 IN.(152 MM)
Only required on sterndrive engines that have the exhaust going through the prop.
Order this kit if the engine has a 2 in.(51 mm) elbow already installed on it, but only
Fits MCM V‑6 with 2 piece exhaust manifolds and 6 in. (152 mm) risers ‑ s/n
needs an additional 4 in.(102 mm) rise. The 2 in.(51 mm) elbow is removed and
0W309999 and below
replaced with the standard rise elbows and a 6 in.(152 mm) riser kit which are
included in kit.
INTERMEDIATE ELBOW KIT
Fits MCM/MIE 8.1L & 8.2L non‑EC engines
RISER KIT - 6 IN.(152 MM)
Only required on sterndrive engines that have the exhaust going through the prop.
Fits MCM V‑8 (305, 350 & 377 cid) engines (0W309999 and below)
This riser will raise the elbow an additional 6 in.(152 mm). If the engine has a 2 in.
INTERMEDIATE ELBOW KIT
(51 mm) elbow already on engine, but only needs an additional 4 in.(102 mm) rise,
this kit will not work. Order 862354A 1 Exh. Elbow/Riser kit instead.
Fits MCM/MIE 8.1L & 8.2L non‑EC engines
Only required on sterndrive engines that have the exhaust going through the prop.
Fits MCM V‑8 (305, 350 & 377 cid) engines with 1.7 in. (43 mm) risers (s/n
0W310000 and up)
US Quicksilver Product Guide
393