Quicksilver Marine Parts Catalog
- Contents
- Pre-1988 Mariner
- Mercury & Mariner
- Carburetor Kits
- Fuel Pump Repair Kits
- Ignition Keys
- Ignition Parts (2-Stroke)
- Ignition Parts (4-Stroke)
- Lower Unit Gearcase Seal
- Pistons
- Oil Filters
- Powerhead Gasket Sets
- Rod Main Bearings
- Solenoid Relay (2-Stroke)
- Solenoid Relay (4-Stroke)
- Spark Plugs (2-Stroke)
- Spark Plugs (4-Stroke)
- Stators
- Thermostat Kits
- Water Pump Parts (2-Stroke)
- Water Pump Parts (4-Stroke)
- Mercruiser
- Engine Parts
- View All »
- Alternators
- Camshafts, Bearings, Lifters & Push Rods
- Carburetors
- Connecting Rod Bearings
- Crankshaft Bearings
- Distributor Assembly & Components
- Distributor Gears
- ECMs, Coils, Wires & Spark Plugs
- Engine Couplers
- Engine Gaskets
- Exhaust Manifolds & Elbows
- Flame Arrestors
- Fuel Coolers
- Fuel Injection Components
- Fuel Pumps & Filters
- Ignition Tune-up Kits
- Intake & Exhaust Valves
- Oil Coolers
- Oil Pumps & Components
- Piston Rings
- Pistons
- Rocker Arms & Hardware
- Starter Parts
- Starters & Solenoids
- Thermostats, Housings & Covers
- Timing Chains & Gears
- Valve Caps, Springs & Keepers
- V-Belts & Serpentine Belts
- Water Hoses—Engine Supply
- Water Hoses—Exhaust Cooling
- View All »
- Transom & Drive Parts
- View All »
- Bearing Carriers
- Bellows
- Drive Shaft Housing & Sterndrive Units
- Drive Shaft Housing Bearings
- Drive Shaft Housing Gears
- Gear Case Bearings
- Gear Case Gears
- Gear Case Seals
- Gear Case Shafts
- Gear Case Shims
- Gimbal Bearings
- Installation Gaskets
- Trim Cylinders
- Trim Cylinder Hardware
- Trim Cylinder Hoses
- Universal Joints (U-Joints)
- Water Pump Impellers & Kits
- View All »
- Engine Parts
- Page Numbers
FUEL SYSTEM
8 FT. FUEL LINE ASSEMBLY
FUEL LINES AND PRIMER BULBS (US-EPA
COMPLIANT)
These products are US‑EPA complaint for the calendar year 2011.
All engines and boats built after Jan. 1, 2009 and subject to US‑EPA
regulations, require the new "Low Permeation" hoses without exception.
Unless otherwise stated, all assemblies shown utilize the Universal 5/16
in. (8 mm) I.D. fuel line assembled with various combinations of primer
bulb and/or fuel line fittings for delivery of fuel to the outboard engine.
9 FT. FUEL LINE ASSEMBLY
Low permeation hose has quick connect type fitting both ends. "EPA‑MERC‑PB15"
primer bulb is included in this 8 ft. (2.44 m) assembly. Bulbs will perform at ‑15
Degrees C (5 Degrees F) after 6 weeks of exposure to fuel.
Fits Force 40 hp. and larger (1993 and Newer), Force 9.9/15/25 hp. (1998) and all
Mercury/Mariner outboards using clip‑on type disconnects at both tank and engine
ends.
Quicksilver Branded, Box Point of Sale Packaged.
8 FT. FUEL LINE ASSEMBLY
This 9 ft. (2.74m) features a screw in fitting on the tank end, our Fuel Demand
Valve, the "EPA‑MERC‑PB15" primer bulb and a quick disconnect on the engine
end. Bulbs will perform at ‑15 Degrees C (5 Degrees F) after 6 weeks of exposure
to fuel.
Quicksilver Branded
9 FT. FUEL LINE ASSEMBLY - NO CONNECTORS
This 8 ft. (2.44 m) fuel line assembly features a quick disconnect on the engine
end, the "EPA‑MERC‑PB15" primer bulb and a male quick connector on the tank
end. Bulbs will perform at ‑15 Degrees C (5 Degrees F) after 6 weeks of exposure
to fuel.
This hose will connect to the pigtail on the new 2011 pressurized 6.6 gallon fuel
tanks.
Quicksilver Branded
8 FT. FUEL LINE ASSEMBLY
There are no ends on this 9 ft. (2.74 m) fuel line assembly featuring the
"EPA‑MERC‑PB15‑2" primer bulb. Bulbs will perform at ‑15 Degrees C (5 Degrees
F) after 6 weeks of exposure to fuel.
This 5/16 inch (8 mm) I.D. fuel line will adapt to a variety of EPA‑2011 uses by
adding connectors as desired.
Quicksilver Branded
Low permeation hose has standard quick connect type fitting on engine end and
1/4" NPT threaded fitting on the tank end. "EPA‑MERC‑PB15" primer bulb is
included in this 8 ft. (2.44 m) assembly. Bulbs will perform at ‑15 Degrees C (5
Degrees F) after 6 weeks of exposure to fuel.
Fits Force 40 hp. and larger (1993 and Newer), Force 9.9/15/25 hp. (1998) and all
Mercury/Mariner outboards using clip on type disconnect at engine ends and a tank
with threaded fuel pickup fitting.
Quicksilver Branded, Box Point of Sale Packaged.
US Quicksilver Product Guide
521