2013 75 optimax fault code 711-24 and 451-25

[Lazeronu]

Hi all,

Just hooked up mercury vessel view mobile to my motor.

I am getting the following faults:

451-25 pitot pressure - the input circuit for the sensor is below the valid limit
711-24 oil level sensor - the input circuit for the sensor is above the valid limit

Are these "ghost codes"? Oil is halfway full. I have not run the boat since to observe if any beeps/warnings went off because I wanted to check in on this first.

Thanks!

 

[Docksidemarineservices]

Pitot is for the speedo.... May not be in use.
Oil level is an optional sensor and may not be in use....

The "Circuit High" / "Circuit Low" Message describes Pull up and pull down sensors.

Unless you have an alarm...You have no issues.

 

[Lazeronu]

Thank you for the response!

 

[Mikey N.C.]

Dockside, x2
Have a '05 ,200 hp at shop, not getting on plane fast. Hooked up laptop, did show 4 commonly known faults. Trim ,oil, and 2 more . but can't be cleared. They are their but no alarm.

 

[Mikey N.C.]

But did see that brown/white . Trim sensor wire was hooked up. But getting code for trim.
They say that's normal.

 

[mykc]

These are normal fault codes if a smartcraft boat sensor harness is not installed (connected)