tilt/trim pin still too high

[1999john25hp]

On my 1999 25HP Johnson, I set the tilt pin at the bottom holes, but the trim still seems a little high at cruising speed. Is there any way to trim it even lower? Considered removing the pin entirely, but I'm guessing that's a bad idea?

 

[fitz73222]

Look into Transom wedges,

CMC Transom Wedges Setback - 2 Degree | T-H Marine

Improve hole shot and trim angle with T-H Marine CMC 2° Transom Wedges—durable, easy install, and optimized outboard performance for better ride and control.

thmarinesupplies.com

 

[racerone]

Pictures of the boat ?----Angle of the transom at about 12 degrees?----A 2 or 3 cylinder motor?

 

[1999john25hp]

Look into Transom wedges,

CMC Transom Wedges Setback - 2 Degree | T-H Marine

Improve hole shot and trim angle with T-H Marine CMC 2° Transom Wedges—durable, easy install, and optimized outboard performance for better ride and control.

thmarinesupplies.com

Thanks!

 

[1999john25hp]

Pictures of the boat ?----Angle of the transom at about 12 degrees?----A 2 or 3 cylinder motor?

2-cyl. Not sure the angle, but it's fairly upright. Looks less steep than 13' whalers.

 

[fitz73222]

Looks very normal, maybe a little tucked in. I wouldn't change it.