Logo

Lower Unit Corrosion

ajv00303

Regular Contributor
I have twin OB's.
The port lower unit is/was exhibiting corrosion, I replaced the zinc thinking it would solve the problem but it seems worse this past season.
Engines are tilted out of the water when not in use. is there a grounding wire I may be missing?
What can I do to repair the damage? Can I clean the area with a wire brush and fill the areas in with MarineTex possibly?
TIA.......Tony
 
I have twin OB's.
The port lower unit is/was exhibiting corrosion, I replaced the zinc thinking it would solve the problem but it seems worse this past season.
Engines are tilted out of the water when not in use. is there a grounding wire I may be missing?
What can I do to repair the damage? Can I clean the area with a wire brush and fill the areas in with MarineTex possibly?
TIA.......Tony
There is a ground wire near the steering tube that might be missing.
 
First thing I would check is whether that anode is actually connected to the case. Paint or corrosion under the mounting pad will insulate it. Then it protects nothing.

Put an ohmmeter between the bare anode pad and bare metal on the gearcase. Should be basically zero. Then check from the gearcase up to the block, and from the port engine over to the starboard one. Twins usually have a bonding jumper between them. If that jumper is gone or green, the port lower unit turns into the anode for both of them...

Fresh water or salt? That matters more than people give it credit for. A zinc passivates in fresh water and quits working. Aluminum is the right anode there. If what you pulled off was aluminum and you put zinc back on, that would explain it getting worse this season.

If it sits in a slip on shore power, look hard at the dock too. A bad ground on the dock will eat a gearcase no matter how good your anodes are.

On the damage. Stainless brush only, not carbon steel, it leaves iron in the aluminum and it comes right back. Clean it to bright metal, etch it, then Marine-Tex is fine for pitting. It is not structural though. If the pitting is deep around the bearing carrier or the seal bore, that housing is done.

I am not a corrosion engineer, that is just what I have seen. Good luck with it.
 
Back
Top