I got this motor recently and replaced the water pump. It has great compression: 125 on all 4. I took it out and it ran very smooth, but only got my 17' Glasply up to 36mph. So I knew it was probably down a cylinder. Found out it was #4. I found that there is no signal to the coil from the power pack. Is there a way to test the trigger? Or just buy a new power pack since that's often the issue with these V4s?
Also, I can't get my tach to work. There is no gray wire coming out of the control box, so I tried running a wire from the terminal block gray and yellow/gray to no avail. The tach does move super slightly when powered up, but doesn't change when the motor is started. I suppose I could have a bad tach, but where should I be able to pick up the signal at? Thanks.
Stephen
Also, I can't get my tach to work. There is no gray wire coming out of the control box, so I tried running a wire from the terminal block gray and yellow/gray to no avail. The tach does move super slightly when powered up, but doesn't change when the motor is started. I suppose I could have a bad tach, but where should I be able to pick up the signal at? Thanks.
Stephen

