Current visitors

Home
Members

AllDodge's latest activity

A

AllDodge replied to the thread Exhaust manifold crack fix?.

You cannot weld cast iron

Jul 22, 2026
A

AllDodge replied to the thread Hot!.

It's possible, what was the napa part number?

Jul 21, 2026
A

AllDodge replied to the thread Please help.

Great news and thanks for the update

Jul 20, 2026
A

AllDodge replied to the thread Oil grade 2001 cat engines.

Your correct, but also it says to use CAT oils https://www.petersoncat.com/sites/cat/files/downloads/Cat%20SAEO.pdf

Jul 20, 2026
A

AllDodge replied to the thread Oil grade 2001 cat engines.

15W40 that specifies to CJ-4 or CK-4 or ECF-3 So Shell Rotella, Mobile Delvac, Vavoline Premium Blue, in short most any Diesel rated oil

Jul 20, 2026
A

AllDodge replied to the thread "Warntonanzeige:Vorglühen nicht möglich".

The breaker or fuse may have blown. Look for it and see if it needs resetting. Might also be the preheat relay is bad or glow plugs...

Jul 18, 2026
A

AllDodge replied to the thread "Warntonanzeige:Vorglühen nicht möglich".

Translation Warning indicator: "Preheating not possible" Appears during startup and disappears 1 minute after the engine (3JH40) has...

Jul 18, 2026
A

AllDodge replied to the thread 3.0 OMC Inboard bogs please help.

It's some kind of a fuel issue, not enough fuel, to much fuel, float not set correctly. New fuel pump but what is the pressure?

Jul 18, 2026
A

AllDodge replied to the thread 3.0 OMC Inboard bogs please help.

The numbers are low but not bad How is the timing advance? Are you getting 30 degrees

Jul 17, 2026
A

AllDodge replied to the thread 3.0 OMC Inboard bogs please help.

Ok

Jul 17, 2026
A

AllDodge replied to the thread 3.0 OMC Inboard bogs please help.

Again, just trying to think what if's Close the fuel bowl, so no air can escape, barometric pressure is 14.7 psi at sea level. Fuel...

Jul 17, 2026
A

AllDodge replied to the thread 3.0 OMC Inboard bogs please help.

Have you done a compression test? Putting your thumb over the bowl vent will probably cause the carb to run lean. With bowl not being...

Jul 17, 2026
A

AllDodge replied to the thread Mercruiser power trim 1979.

Disconnect the pump from everything Connect the pump direct to Bat using Blue and Black or swap feeds to Green and Black connections...

Jul 16, 2026
A

AllDodge replied to the thread 4.3 Mercruiser Vortex.

Use a voltmeter and trace power 12V on Bat, then check starter, then check 50 amp breaker, then check slave solenoid. Go behind the helm...

Jul 16, 2026
A

AllDodge replied to the thread Boat engine overheated and cut out..

You blew a head gasket or cracked the head. Pull the head and inspect and hope it's just the gasket and not a cracked head

Jul 16, 2026

Show older items

Home
Members

Top