Logo
FULL SITE MENU

Recent content by Garygin

  1. Garygin

    Instruments

    Curious to find out what instruments people are running on your Honda engines
  2. Garygin

    Honda 225 coils

    Thanks Chawk . I couldn’t find any reference to resistance on coils either
  3. Garygin

    Honda 225 coils

    Would like to get some input on resistance readings on my coils. On 4 out of the 6 the readings are roughly about the same 4.5 ohms. But on 2 of them the reading is about 2 ohms . Is it possible that they could be bad. Thanks for any imput
  4. Garygin

    IAB vacuum

    The IAB valves are completely functional. I have had it apart several times . The only thing that I haven’t replaced is the IAB solenoid, but I tested it . When I connect it to the 2pin connector you cannot hear it click. When I put 12 volts to directly it sounds fine , and it checks to the...
  5. Garygin

    IAB vacuum

    No apology needed. But I still have the issue of the #9 pin on the ECU having no continuity to ground.
  6. Garygin

    2004 BF225 25" extension case driveshaft bearing (bushing) question

    Great! Job well done. No issues? Congratulations
  7. Garygin

    IAB vacuum

    Will do. Thank you
  8. Garygin

    IAB vacuum

    Ok . I checked from the #9 pin to ground and there is continuity. So are thinking what I’m thinking .. New ECU?
  9. Garygin

    IAB vacuum

    I checked everything. I ran all of these tests yesterday. I followed your instructions as the manual and tested again. I figured it can’t hurt. I have the same results. #5 fuse is good, 12 Volts from Y/BL to ground. No continuity between #2 pin and ground. I pulled the 26 pin connector pin and...
  10. Garygin

    IAB vacuum

    Thank you Chawk man . I will check that right away.
  11. Garygin

    IAB vacuum

    FYI . When I hook the solenoid to its 2 pin connector and energize it you cannot hear the check valve open. I only hear it when I put 12 volts directly to the terminals on the solenoid. Also if I check the Y/BK wire on the 2 pin and a ground I Have 12 volts
  12. Garygin

    IAB vacuum

    Ok Chawk man. I checked everything. What I found was that there is no continuity between the black pin on the 2 pin harness to ground .so what the book says is to replace the ECM. I checked the IAB solenoid and it checks out fine. It has continuity , and when 12 volts is applied you can hear...
  13. Garygin

    IAB vacuum

    Ok what I have is the Honda shop manual. The pages you gave coincide with my shop manual.
  14. Garygin

    IAB vacuum

    Will do. Question, is the helm manual any different than the Honda service manual?
  15. Garygin

    IAB vacuum

    I’ll check it tomorrow and let you know
See more
Back
Top