Logo
FULL SITE MENU

kghost's latest activity

  • kghost
    kghost replied to the thread “Pre alpha” leak.
    A little more goop vs less is not a bad thing when Orings are invloved. I use a LOT!
  • kghost
    kghost replied to the thread Thermostat parts.
    That is exactly what it should be 110-120* with No thermostat. Please if you can, Post some photos of your housing including the...
  • kghost
    kghost replied to the thread “Pre alpha” leak.
    """Pulled carrier a second time cleaned and inspected bore, looked good.""" What exactly is LOOKED GOOD? I have had many drives apart...
  • kghost
    kghost replied to the thread Thermostat parts.
    As far as part fitment goes, We are unable to see the condition of the housing. Is it full of rust scale? The cast iron could have...
  • kghost
    kghost replied to the thread Thermostat parts.
    FYI, There is a reason for a 140* thermostat to be used in a RAW water cooled Marine engine, It is to help keep the salt in salt water...
  • kghost
    kghost replied to the thread Thermostat parts.
    Link for this web site for YOUR ENGINE 350 ci 260 HP1988-1995 SERIAL NUMBERS - GM-350-V8-19881995 (0b525982-thru-0f600999)...
  • kghost
    kghost replied to the thread Thermostat parts.
    WRONG WRONG WRONG AUTO vs MARINE for many things are not the same. DO NOT EQUATE these two in the future you will end up with serious...
  • kghost
    kghost replied to the thread Thermostat parts.
    Why a 160* thermostat? Most used are 140*
  • kghost
    kghost replied to the thread Mercruiser Wire Harness Help.
    Update: Received a text message with video of the engine running. He basically did a huge amount of rewiring following the schematic and...
  • kghost
    kghost replied to the thread mercruiser shift cable install tool to help it tthru the bellow.
    Really, Glycerine.... Dawn dish soap works perfectly well.
  • kghost
    kghost replied to the thread Mercruiser Wire Harness Help.
    No resistor wire, No points, Pertronix kit and blaster coil.... Prior owner butchered the wiring.......
  • kghost
    kghost replied to the thread Mercruiser Wire Harness Help.
    Schematic of Dash wiring and pin outs of connector. I added Blue type for Jgallo as he may remove the Amp meter and replace with Volt...
    • 888 dash schematic.jpg
    • 888 schematic.jpg
  • kghost
    kghost replied to the thread Mercruiser Wire Harness Help.
    I believe that that resistanve wire, even though it shows at choke, actually is/should be burried in the harness as a multi wire...
  • kghost
    kghost replied to the thread Mercruiser Wire Harness Help.
    • 888 schematic.jpg
  • kghost
    kghost replied to the thread Mercruiser Wire Harness Help.
    Some of the wire colors are wrong. post your phone number way to much to type Ten minutes then I am out!!!
Show older items
Back
Top