Logo

1992 johnson 40 2 stroke won’t run in water

Tracker92RTR

New member
I can get my motor to crank pretty good in the driveway on muffs but when I put it in the water the starter will engage and keep the fly wheel spinning but won’t turn the motor over. My batteries seem to be getting drained as well. I have a 24c 750 cranking amp battery that was connected to the engine that had a live well and bilge pump on it as well but they were never running. The other is an 850
Which I just moved the cranking electronics on it by itself to try and fix it. So I am unsure of what my issue is. And I have also cleaned the carbs, replaced fuel lines, the bulb, added lower unit gear oil, and the impeller pumps great
 
<p>Muffs are not a load test. In the water the exhaust relief goes under, backpressure comes up, and the motor needs more cranking speed and a hotter spark to light. A 40 that pops on muffs and does nothing in the water is usually weak ignition at cranking volts, not a carb problem.</p><p><br></p><p>First thing I would do is put a meter on the starter post and crank it in the water. Watch what it pulls down to. If it sags below about 10.5 the CD pack will not fire. Two batteries and a livewell circuit sharing that post is a good place to lose volts.</p><p><br></p><p>Clean both cable ends and the block ground and torque them. Cheap, and that one has bitten me more than once.</p><p><br></p><p>Then spark, with an adjustable tester set to 7/16, both cylinders, in the water. A plug laid on the block will lie to you. Compression next, throttles open. If one hole is down you get exactly this.</p><p><br></p><p>SWAG on the rest. A primer solenoid stuck open floods it once there is backpressure. Pinch the primer hose and try. A pinhole in the pump diaphragm pushes raw fuel up the pulse line into the crankcase, and that only shows under load.</p><p><br></p><p>One question. When you say the starter keeps the flywheel spinning, is the crank actually turning? Pull the plugs and watch the pistons. A loose flywheel nut will spin the hub and never turn the motor.</p><p><br></p><p>Good luck with it.</p>
 
Back
Top