Logo
D
Reaction score
0

Latest activity Postings About

    • D
      Droid replied to the thread 1985 3L.
      Blocks are different, 85 uses 2 piece rear main seal, 94 uses 1 piece. Heads are different too but use same gasket. I believe the later...
    • D
      Droid replied to the thread Winterizing closed cooled 5.0.
      Lou, that central drain contraption fills with sand & causes further issues when the unsuspecting believe the engine is drained. It...
    • D
      Droid replied to the thread Is my Chinese Fuel pump Bad????.
      I have no confidence in Chineesium parts BUT you need to verify no air leak from bottom of fuel tank pick up tube all the way to the...
    • D
      Droid replied to the thread Winterizing closed cooled 5.0.
      I agree with Alldodge in post #7. There is 1 thing to consider however & that is IF sedement (typically sand) has settled in low spots...
    • D
      Droid replied to the thread Steering cable.
      I assume you have done the obvious & untreated it from the tilt tube & removed the nut from the link on the other end. So if it truly...
    • D
      Q8 is Quicksilver. A8 is Mercury Marine. Same part, different color package. 46-57234A1 is for the pre-Alpha "R" & MC1 drives.
    • D
      The Mercruiser parts book groups R/MR/Alpha 1 all in the same serial number run of drives. So, parts guy made an easy mistake. FYI: R is...
    • D
      Like Alldodge said, pump oil in & see where it comes out. Put your finger over the seal recess. There are 2 different water pump bases...
    • D
      Like I said above that drains the casting of any accumulated water so it doesn't freeze. Your missing the seal #7
    • D
      Your missing the quad ring seal where the upper & lower meet. Item #7, p/n 26-45577 1 I assume it's flowing down into the hollow nose...
    • D
      Droid replied to the thread water coming out of #1 spark plug.
      2 blue wires from bottom of tank. They are (should be) in a sleeve going to alarm module not far away. Disconnect the wires at the...
    • D
      Droid replied to the thread mercruiser gear ratio.
      Wasn't there a data placard on the rain bonnet over the carb & distributor also? You could always take the top cover off & count the...
    • D
      The forward gear is shimmed by way of shims in the housing nose prior to the race being installed. There is no shimming required with...
    • D
      The trick to dislodging the pinion gear from the drive shaft is to back the nut off only until flush with threads then (if I recall...
    • D
      You have a good running engine 3' away. So swap parts 1 at a time until you discover your problem. I would start with the ignition coil...
  • Loading…
  • Loading…
Back
Top