Logo
FULL SITE MENU

Search results

  1. K

    Can a bent skeg be straightened?

    Hi folks, Hit small rock pile while idling in gear & bent the skeg about 1/2" to port. Can it be straightened? What is the procedure? Thanks!
  2. K

    Prop nut...lining up shaft hole with cotter groove question.

    When following the Honda service procedure, my castle nut is almost hand tight after properly torqueing (sp?) and backing off to the nearest available cotter groove. Prop, thrust washers, & nut are all Honda O.E. parts. Is there a "magic" nut with off-set grooves? Or maybe a shim/washer? Thx!
  3. K

    S/S prop noise?

    Once again I am seeking the input from the pros on this forum...Finally got my new boat in the water (winter sucks) with a new BF150...Ordered new with an S/S prop. Definitely not the quiet Honda sound I'm used to, its noisy down low, especially in reverse. Local Marine shop says S/S prop is the...
  4. K

    Where can I get a scan tool?

    Is there a marine scan tool available from either Honda or the aftermarket? Or is there an adapter available that would allow connection of an automotive HDS or similar scan tool? Any recommendations would be appreciated, thanks.
  5. K

    NMEA 2000 question

    Hey guys, I have a new BF150 and want to run the NMEA 2000. I’m using a Garmin echomap plus 74CV. Do I only need Honda’s NMEA 2000 cable? Or is there something else? Appreciate any input on this, thanks!
  6. K

    Adding a trim tilt gauge to a BF150A

    Hi all, new to forum.... I have a new 2018 BF150A. I was wondering what's involved with adding a trim/tilt gauge. I was told that the sensor is factory-installed, and that all I need to do is buy a gauge and plug it into the factory harness. I will use a Honda gauge. Is that all there is to it...
Back
Top