Logo
FULL SITE MENU

Search results

  1. S

    2006 Yamaha F115 VST drain?

    Getting a boat my dad had sitting for yrs into running condition. Want to drain the VST but I can't seem to find the drain screw. I released what little pressure was in the fuel rail using the schrader valve on top of the rail. I also found the little black rubber plug with a "tab" on it (...
  2. S

    How do you remove the starter relay off a F115?

    So working a won't start issue on my F115. Starter bench tests ok so want to check the relay. I "think" I have a bad relay on my 2006 yamaha F115TXR I have removed the starter and bench tested it and it seems to be good. I want to remove the relay and bench test it using 12v at my work bench...
  3. S

    2006 F115 starter won't turn engine over

    So I had a thread going last month and was getting some good advice but then the person helping me stopped responding. I don't know why. Maybe they got tired of my questions or something....' The engine on my motor won't turn over. I can turn it by hand (with the plugs out) so I know it's...
  4. S

    2007 F115 starter relay position and how do you "jump it"?

    Trying to locate the starter relay. I think it's a small squarish black "box" with 2 wires on it that's suppose to be near the starter. Is it on the front side down low to the right of the fuse box? And how do you "jump" it to bypass it to see if the starter turns/ Just use a short wire and...
  5. S

    2007 Yamaha F115 safety switch?

    Ok, I'll probably get roasted for this question but is there a safety switch of some sort that prevents the engine from starting/turning over when it is in the fully up position? I shipped my PTT off to get rebuilt and wanted to fog the cylinders and turn the engine over to distibute the...
  6. S

    2006 Yamaha F115 lower pin on PTT unit won't budge.

    Any ideas on getting the lower pin on the PTT unit out? The top one with the C clip pushed out using just my finger but the lower one won't budge. I tried driving it out with a wood dowel and hammer but no luck either. I then put penetrating oil on both outside and inside areas (as best i...
Back
Top