Logo

4.3mpi stutters above 3600

mark123

Member
What are some things that trigger the guardian system. My 2006 4.3mpi will not go above 3600. It stutters if more throttle is given. Sounds like ignition cutting out, guess its limp mode . New fuel filter, oil pressure good, temperature good at 175. Gear oil good. New temp sensor. Could bad water pressure sensor at back of engine cause this? Left side of thermostat housing yemp sensor I did not change? I changed the temp one on right side. Everything works perfect up until exactly 3600. Prop is good and same one as before issue started. New plugs, IAC, fuel pump, both regulators, fuel pressure tested good, new cap and rotor. Oil level good. I did not change plug wires yet but intend to. Thanks
 
Im in Canada so paying shipping and exchange etc...for a rental is too expensive, ill likely just buy one locally.
Fuel pressure is within spec at all rpm.
Another forum someone mentioned could be bad ignition sensor inside distributor, does that sound possible
 
Im in Canada so paying shipping and exchange etc...for a rental is too expensive, ill likely just buy one locally.
Fuel pressure is within spec at all rpm.
Another forum someone mentioned could be bad ignition sensor inside distributor, does that sound possible
While the Cam sensor inside the distributor seems less likely, honestly anything is possible at this point... The following may be of a helpful guide for you too should it be within these scenarios... Is the warning horn sounding off too at 3600 RPM??



Maybe a different idea to consider looking into too... Go to your local Canada craigslist, under services, look for marine and see if maybe there's a mobile marine boat tech that has a scan tool that could swing by and scan the engine for you.

^ Or get/buy either a smart craft gauge or mercruiser vessel view mobile app system to help scan for fault codes too...

 
Back
Top