Logo

50HP Evinrude power module

richuno

New member
"After fixing a broken wire on

"After fixing a broken wire on my power module I took the boat out the first time and all was O.K. but 2nd time out I got a failure again where engine bogs down just as it did with the wire broken. When the engine is cool it takes off well but seems to bog down when warm. I purchased a new power pack module that just arrived. I have this question, there is two cables one orange/green and the other orange/blue. Both of these wires go to the ignition coil. one is on the top and the other on the bottom. Does it matter where these wires go when connected to the ignition coil? What if they are reversed what would happen? appreciate your help..."
 
It won't run.You have to h

It won't run.You have to have the correct coil fire when its piston is at the top.If you hooked it up wrong you would have to reverse the plug wires --- get it???
 
"Just to be sure. These are th

"Just to be sure. These are the two wires that come from the power module, is this correct. If these are inverted then engine will not start?

Regards,
Richard"
 
"After fixing a broken wire on

"After fixing a broken wire on my power module I took the boat out the first time and all was O.K. but 2nd time out I got a failure again where engine bogs down just as it did with the wire broken. When the engine is cool it takes off well but seems to bog down when warm. I purchased a new power pack module that just arrived. I have this question, there is two cables one orange/green and the other orange/blue. Both of these wires go to the ignition coil. one is on the top and the other on the bottom. Does it matter where these wires go when connected to the ignition coil? What if they are reversed what would happen? appreciate your help..."
 
Back
Top