gardarkristjans
New member
Hi there i´m new in this group.
I have a Yanmar 6LY3-ETP
i8320P Engine Interface Module
Yanmar i5601e Display
CH64600: Single Control Head
The problem is that i don´t get any information to the display from the engine (I see the control head in the network nodes but not the i8320P)
I have the T connectors and male and female terminators
This is the diagram for the connections
The three leds on the ECU - I always see NMEA ligth blink and sometimes the Engine Com Blink but never seen the ECU status light.
And one thing i noticed is that when the engine is running the Volts drops down to 9V for a few minutes and then go back to 12.
Does anybody have any clue what is going on?
Sorry for the typing
Best regards
Gardar
I have a Yanmar 6LY3-ETP
i8320P Engine Interface Module
Yanmar i5601e Display
CH64600: Single Control Head
The problem is that i don´t get any information to the display from the engine (I see the control head in the network nodes but not the i8320P)
I have the T connectors and male and female terminators
This is the diagram for the connections
The three leds on the ECU - I always see NMEA ligth blink and sometimes the Engine Com Blink but never seen the ECU status light.
And one thing i noticed is that when the engine is running the Volts drops down to 9V for a few minutes and then go back to 12.
Does anybody have any clue what is going on?
Sorry for the typing
Best regards
Gardar