Logo
FULL SITE MENU

Latest activity

What's new New posts Latest activity
  • I
    itschriswilliams replied to the thread how to re-install shift linkage on 60hp Johnson J60TLCDS ?.
    This is the answer. Everything else is sub par. I spent all day trying to get it back together. I own the service manual. None of the...
  • J
    jgmo replied to the thread Honda BF-20D Carb Repair.
    Well, no problem about speedyness. Time is part of my riches. The problem is that the 20 D carb is a bit more sophisticated and finicky...
  • B
    bspeth replied to the thread 1972 Evinrude 18HP Having Some Trouble Getting her Going.
    Get the open air tester and use it in low light if possible. Pull both plugs for the test for easier turnover. Use your drill to spin...
  • C
    cflowers replied to the thread Tohatsu 9.8 Impeller replacement.
    I installed the water pump kit and the new water tube gasket and the engine is pumping water again. This part of the saga is closed...
  • J
    jimn replied to the thread Shifting to Neutral for starting.
    I lubed mine with Quicksilver 2-4-C but that was because I needed to disassemble for replacing the shift cable. Mine is an '84 4 Winns...
  • J
    jimn replied to the thread 4.3 Mercruiser - randomly dies.
    True, but the battery manufacturers could save money by omiotting the nuts. OTOH, that will give dealers something else to biatch about...
  • W
    Wjohnson replied to the thread Honda BF-20D Carb Repair.
    jgmo, Sorry for not responding sooner, we had out of town guests for three days and I didn't get back to the motor until this...
  • R
    racerone replied to the thread 2004 115 Johnson stalls after 3 min.
    Perhaps the ---SO---makes it an 2005 model
  • J
    jgmo replied to the thread Honda 225 will not turn over / tilt not working.
    THAT WAS TOO EASY!!! 🤣 Kidding! Glad you found the problem. Thanks for updating. You could though use that bad cable as a prop to...
  • J
    jgmo replied to the thread BF40E issue.
    Water vaporator?? Some new fangled, space age device for 2024 I guess... ...OR If you mean water SEPARATOR, it's NOT supposed to be...
  • makomark
    makomark replied to the thread Water in Oil.
    Leave the recirculation hose connected ...measure the hose nipple for the raw water inlet, gat a 3" piece of reinforced hose, and then...
  • L
    louc replied to the thread Water in Oil.
    Smoke machines are very useful; I’ve fixed a couple of check engine light issues on my Jeeps with it but yea it could also be used for...
  • T
    Tclark replied to the thread Water in Oil.
    I want to test the block for internal crack...Blow 15psi into temp sensor port on thermostat housing. So I want the entire stat housing...
  • makomark
    makomark replied to the thread Water in Oil.
    You want to plug the recirculation an raw water in hoses?
  • T
    Tclark replied to the thread Water in Oil.
    Thats a good idea.... still got recirc and raw water in
Show older items
Back
Top