Quicksilver Marine Parts Catalog
- Contents
- Pre-1988 Mariner
- Mercury & Mariner
- Carburetor Kits
- Fuel Pump Repair Kits
- Ignition Keys
- Ignition Parts (2-Stroke)
- Ignition Parts (4-Stroke)
- Lower Unit Gearcase Seal
- Pistons
- Oil Filters
- Powerhead Gasket Sets
- Rod Main Bearings
- Solenoid Relay (2-Stroke)
- Solenoid Relay (4-Stroke)
- Spark Plugs (2-Stroke)
- Spark Plugs (4-Stroke)
- Stators
- Thermostat Kits
- Water Pump Parts (2-Stroke)
- Water Pump Parts (4-Stroke)
- Mercruiser
- Engine Parts
- View All »
- Alternators
- Camshafts, Bearings, Lifters & Push Rods
- Carburetors
- Connecting Rod Bearings
- Crankshaft Bearings
- Distributor Assembly & Components
- Distributor Gears
- ECMs, Coils, Wires & Spark Plugs
- Engine Couplers
- Engine Gaskets
- Exhaust Manifolds & Elbows
- Flame Arrestors
- Fuel Coolers
- Fuel Injection Components
- Fuel Pumps & Filters
- Ignition Tune-up Kits
- Intake & Exhaust Valves
- Oil Coolers
- Oil Pumps & Components
- Piston Rings
- Pistons
- Rocker Arms & Hardware
- Starter Parts
- Starters & Solenoids
- Thermostats, Housings & Covers
- Timing Chains & Gears
- Valve Caps, Springs & Keepers
- V-Belts & Serpentine Belts
- Water Hoses—Engine Supply
- Water Hoses—Exhaust Cooling
- View All »
- Transom & Drive Parts
- View All »
- Bearing Carriers
- Bellows
- Drive Shaft Housing & Sterndrive Units
- Drive Shaft Housing Bearings
- Drive Shaft Housing Gears
- Gear Case Bearings
- Gear Case Gears
- Gear Case Seals
- Gear Case Shafts
- Gear Case Shims
- Gimbal Bearings
- Installation Gaskets
- Trim Cylinders
- Trim Cylinder Hardware
- Trim Cylinder Hoses
- Universal Joints (U-Joints)
- Water Pump Impellers & Kits
- View All »
- Engine Parts
- Page Numbers
ELECTRICAL
POWER TRIM EXTENSION HARNESS
ADAPTER - NON DTS 14 PIN TO 10 PIN
Adapter that allows you to connect engines that have the newer 14 pin engine
24 ft.(4.88 m) harness.
harness to the older 10 pin helm harness
This harness connects the remote control 4 pin Molex connector to the newer
design 3 pin Packard pump trim pump connector.
MCM/MIE engines that have the 14 pin engine harness. Also used on Race
product (outboards only) that have a 14 pin engine harness being connected to a
MCM/MIE
10 pin helm harness.
POWER TRIM ADAPTOR HARNESS
REMOTE CONTROL EXTENSION HARNESSES
POWER TRIM EXTENSION HARNESS
12 in.(305 mm) harness.
To convert older P/T pump with 3 blade connector to newer remote control harness
with 3 pin Packard connector.
POWER TRIM ADAPTOR HARNESS
16 ft.(4.88 m) harness.
This harness connects the remote control 4 pin Molex connector to the traditional
3 blade Mercury pump trim pump connector.
MCM/MIE
24 ft.(4.88 m) harness.
This harness connects the remote control 4 pin Molex connector to the traditional 3
blade Mercury pump trim pump connector.
MCM/MIE
POWER TRIM EXTENSION HARNESS
12 in.(305 mm) harness.
To convert newer P/T pump with 3 pin Packard connector to older remote control
harness with 3 blade connector.
16 ft.(4.88 m) harness.
This harness connects the remote control 4 pin Molex connector to the newer
design 3 pin Packard pump trim pump connector.
MCM/MIE
US Quicksilver Product Guide
257