Quicksilver Marine Parts Catalog
- Contents
- Pre-1988 Mariner
- Mercury & Mariner
- Carburetor Kits
- Fuel Pump Repair Kits
- Ignition Keys
- Ignition Parts (2-Stroke)
- Ignition Parts (4-Stroke)
- Lower Unit Gearcase Seal
- Pistons
- Oil Filters
- Powerhead Gasket Sets
- Rod Main Bearings
- Solenoid Relay (2-Stroke)
- Solenoid Relay (4-Stroke)
- Spark Plugs (2-Stroke)
- Spark Plugs (4-Stroke)
- Stators
- Thermostat Kits
- Water Pump Parts (2-Stroke)
- Water Pump Parts (4-Stroke)
- Mercruiser
- Engine Parts
- View All »
- Alternators
- Camshafts, Bearings, Lifters & Push Rods
- Carburetors
- Connecting Rod Bearings
- Crankshaft Bearings
- Distributor Assembly & Components
- Distributor Gears
- ECMs, Coils, Wires & Spark Plugs
- Engine Couplers
- Engine Gaskets
- Exhaust Manifolds & Elbows
- Flame Arrestors
- Fuel Coolers
- Fuel Injection Components
- Fuel Pumps & Filters
- Ignition Tune-up Kits
- Intake & Exhaust Valves
- Oil Coolers
- Oil Pumps & Components
- Piston Rings
- Pistons
- Rocker Arms & Hardware
- Starter Parts
- Starters & Solenoids
- Thermostats, Housings & Covers
- Timing Chains & Gears
- Valve Caps, Springs & Keepers
- V-Belts & Serpentine Belts
- Water Hoses—Engine Supply
- Water Hoses—Exhaust Cooling
- View All »
- Transom & Drive Parts
- View All »
- Bearing Carriers
- Bellows
- Drive Shaft Housing & Sterndrive Units
- Drive Shaft Housing Bearings
- Drive Shaft Housing Gears
- Gear Case Bearings
- Gear Case Gears
- Gear Case Seals
- Gear Case Shafts
- Gear Case Shims
- Gimbal Bearings
- Installation Gaskets
- Trim Cylinders
- Trim Cylinder Hardware
- Trim Cylinder Hoses
- Universal Joints (U-Joints)
- Water Pump Impellers & Kits
- View All »
- Engine Parts
- Page Numbers
ELECTRICAL
LANYARD STOP SWITCH
OPTIONAL REMOTE CONTROL HARNESSES
REMOTE CONTROL HARNESS
5 ft.(1.53 m) harness. 2 inch cut out with Black bezel. Used when mounting
controls with no lanyard switch included.
Chrome bezel optional ‑ order separate.
15‑1/2 ft.(4.7 m) ten‑wire cable for large boats when standard remote control cable
MCM/MIE engines. Do not use on DTS engines
is too short.
Quicksilver Branded, Hanging Box Point of Sale Packaged.
Fits Force (1992 and prior) outboards with 10‑wire engine harnesses.
LANYARD STOP SWITCH
19 ft.(5.8 m) ten‑wire cable for large boats when standard remote control cable is
too short.
Fits Force (1992 and prior) outboards with 10‑wire engine harnesses.
LANYARD STOP SWITCHES
Lanyard cord attaches to the toggle switch or cap and boat driver. When
switch toggles or cap pulls off switch, the ignition is interrupted and the
engine shuts down.
LANYARD STOP SWITCH
5 ft.(1.53 m) harness. Surface or Flush mount. Used when mounting controls with
no lanyard switch included
Used on Outboards and DTS engines
Quicksilver Branded, Hanging Box Point of Sale Packaged.
LANYARD STOP SWITCH
5 ft.(1.53 m) harness. Surface mount or flush mount. Used when mounting
controls with no lanyard switch included
MCM/MIE engines. Do not use on DTS engines
Quicksilver Branded, Hanging Box Point of Sale Packaged.
5 ft.(1.53 m) harness. 2 inch cut out with Black bezel. Used when mounting
controls with no lanyard switch included.
Chrome bezel optional ‑ order separate.
Used on Outboards and DTS engines
Quicksilver Branded, Hanging Box Point of Sale Packaged.
258