Quicksilver Marine Parts Catalog
- Contents
- Pre-1988 Mariner
- Mercury & Mariner
- Carburetor Kits
- Fuel Pump Repair Kits
- Ignition Keys
- Ignition Parts (2-Stroke)
- Ignition Parts (4-Stroke)
- Lower Unit Gearcase Seal
- Pistons
- Oil Filters
- Powerhead Gasket Sets
- Rod Main Bearings
- Solenoid Relay (2-Stroke)
- Solenoid Relay (4-Stroke)
- Spark Plugs (2-Stroke)
- Spark Plugs (4-Stroke)
- Stators
- Thermostat Kits
- Water Pump Parts (2-Stroke)
- Water Pump Parts (4-Stroke)
- Mercruiser
- Engine Parts
- View All »
- Alternators
- Camshafts, Bearings, Lifters & Push Rods
- Carburetors
- Connecting Rod Bearings
- Crankshaft Bearings
- Distributor Assembly & Components
- Distributor Gears
- ECMs, Coils, Wires & Spark Plugs
- Engine Couplers
- Engine Gaskets
- Exhaust Manifolds & Elbows
- Flame Arrestors
- Fuel Coolers
- Fuel Injection Components
- Fuel Pumps & Filters
- Ignition Tune-up Kits
- Intake & Exhaust Valves
- Oil Coolers
- Oil Pumps & Components
- Piston Rings
- Pistons
- Rocker Arms & Hardware
- Starter Parts
- Starters & Solenoids
- Thermostats, Housings & Covers
- Timing Chains & Gears
- Valve Caps, Springs & Keepers
- V-Belts & Serpentine Belts
- Water Hoses—Engine Supply
- Water Hoses—Exhaust Cooling
- View All »
- Transom & Drive Parts
- View All »
- Bearing Carriers
- Bellows
- Drive Shaft Housing & Sterndrive Units
- Drive Shaft Housing Bearings
- Drive Shaft Housing Gears
- Gear Case Bearings
- Gear Case Gears
- Gear Case Seals
- Gear Case Shafts
- Gear Case Shims
- Gimbal Bearings
- Installation Gaskets
- Trim Cylinders
- Trim Cylinder Hardware
- Trim Cylinder Hoses
- Universal Joints (U-Joints)
- Water Pump Impellers & Kits
- View All »
- Engine Parts
- Page Numbers
FUEL SYSTEM
PRIMER BULB ASSEMBLY
8 FT. FUEL LINE ASSEMBLY
Using materials resistant to the chemistry of today's fuels, this bulb is designed to
Low Permeation hose has standard quick connect type fitting on engine end and
remain pliable longer. Two hose clamps are included. Mercury/Quicksilver bulbs
1/4" NPT threaded fitting on the tank end. Primer bulb is included in this 8 ft. (2.44
will have the molded EPA compliance statement "EPA‑MERC‑PB15". Bulbs will
m) assembly.
perform at ‑15 Degrees C (5 Degrees F) after 6 weeks of exposure to fuel.
Fits Force 40 hp. and larger (1993 and Newer), Force 9.9/15/25 hp. (1998) and all
This bulb is a 2011 EPA Certified low permeation bulb. For use with our gray color,
Mercury/Mariner outboards using clip on type disconnect at engine ends and a tank
5/16 in. (8 mm) I.D. fuel line & 3/8" I.D. fuel line.
with threaded fuel pickup fitting. This assembly may be used in all applications not
governed by US‑EPA 2011 regulations.
Quicksilver Branded, Box Point of Sale Packaged.
Quicksilver Branded, Box Point of Sale Packaged.
8 FT. FUEL LINE ASSEMBLY
FUEL LINES AND PRIMER BULBS - (NON-US
COMPLIANT)
These assemblies may be used in all applications not governed by the
US‑EPA 2011 regulations. If those regulations do apply, please refer to
a 2011 US Compliant Section either here or in an Accessories Guide for
applicable assemblies complete with provision for a pressurized fuel
tank and low permeation primer bulb.
8 FT. FUEL LINE ASSEMBLY
Low Permeation hose has double sealed quick connect type fitting on tank end and
clip‑on type quick connect on engine end. Primer bulb is included in this 8 ft. (2.44
m) assembly.
Fits Force 40 hp. and larger (1993 and Newer), Force 9.9/15/25 hp. (1998) and all
Mercury/Mariner outboards using clip‑on type disconnects at both tank and engine
ends. This assembly may be used in all applications not governed by US‑EPA
2011 regulations.
Quicksilver Branded, Box Point of Sale Packaged.
8 FT. FUEL LINE ASSEMBLY
Low Permeation hose has 1/8" NPT threaded fitting on engine end and 1/4" NPT
threaded fitting on the tank end. Primer bulb is included in this 8 ft. (2.44 m)
assembly.
Fits varying applications using the older style twist type disconnects at the engine
end and either a bayonet or thread‑in fitting on the tank end. This assembly may
be used in all applications not governed by US‑EPA 2011 regulations.
Quicksilver Branded, Box Point of Sale Packaged.
Has double sealed quick connect type fitting on (Super) tank end and no fitting on
engine end. Primer bulb is included in this 8 ft. (2.44 m) assembly.
Fits remote model 40‑60 hp. FourStroke Mercury/Mariner outboards 2008 and
newer. US‑EPA regulated engines and boats may not use this hose.
US Quicksilver Product Guide
523