Logo
FULL SITE MENU

Recent content by beantown

  1. B

    Tidying the rigging tube/engine connection

    I installed my BF225's last year and part #3 "grommet" is rubber and has an individual properly sized hole for each cable/line/hose. There are slices in the grommet that allow you to slide each cable/line/hose up into its spot. (don't have to disconnect a hose to push it through). The plastic...
  2. B

    Intermittent Overheats 2007 BF225, but only when in 100gallon dunk tank

    Have yet to get an alarm on the ocean, but when I return home I have a 100+ gallon tub that allows me to run and flush both motors at same time. The intake screens are about a foot under water and the hose stays on to keep the tub fresh. Outboards are both trimmed level. Impellers...
  3. B

    Should I mount my engine higher? (jack plate content)

    I just wrote a book and it all went *poof when I clicked post. I’ll at least post the picture for reference. Too annoyed to retype all that again right now.
  4. B

    Dialing in the twin 2007 BF225’s

    I bought a 1993 Grady White 252 Sailfish near end of boating season last year. On its maiden voyage, it had tired twin 200 Yamaha 2 strokes, that were so tired I ripped the block almost in half when a rod in the port motor gave up the ghost. While limping back on 1 motor, it also died, but...
See more
Back
Top