Logo
FULL SITE MENU

Recent content by boatiebur

  1. B

    Joe Reeves timing method ???

    After doing a lot of reading regarding the Joe Reeves method I have a question regarding idle timing. From what I can gather, this method sets the WOT timing using a timing light. If this is set correctly will the idle timing be very close to where it should be? If the throttle valves are...
  2. B

    Do I need to do a link sync???

    As you can see the roller is below the cam marker line. I haven't touched any of the settings on this engine. Like I said it idles perfectly but can only run at 4000rpm at full throttle. Help???
  3. B

    Do I need to do a link sync???

    Hi all. I have a Johnson 70 hp 1975 model 70ESL75B. The linkages have been set up like this since I have owned the boat. The boat idles perfectly but runs rough at wot. Is the cam follower the problem as it is not in the center of the roller? What do I need to do? :o
  4. B

    Removal of steering cable Johnson 70hp

    Hi all. I have a Johnson 70hp 1975 on a 1600 silverline hull. I'm unable to pull the cable from the outboard motor end as there isn't enough room. I've read in other forums that sometimes the engine needs to be removed to get the cable out. The rod that attaches to the outboard won't pull...
  5. B

    Replacing thermostat Johnson 1975 70 HP

    Recently purchased a thermostat for my Johnson 70 hp and have identified what needs to be done. I have done some reading on this topic but I'm worried about snapping a bolt on the powerhead. Are there any ways to try and prevent this from happening. Should i heat the engine up first. Should...
  6. B

    Johnson 70hp 1975 outboard prop

    What would be the best prop for my boat. I have a 15 ft runabout that I like to use for cruising. What was the standard size prop Johnson would use for these older outboards. I am relatively new to boating and I'm curious to read your feedback.
See more
Back
Top