Logo
FULL SITE MENU

Search results

  1. B

    BF150 Decals

    Repainting engine cowlings, need a source for decals BF150 Thanks Greg
  2. B

    Emergency stop circuit

    2004 BF150, Engine starts and runs with or without the "Dead Man" clip in place. While trouble shooting found a broken wire (blk /w red trace) on the ignition switch, part of the grounding system and indicator light. Could not repair so replaced the ignition switch, did not solve the problem...
  3. B

    PGM indicator Panel not lighting

    I have twin BF150, the PGM indicator panel does not light up on the stud engine when I turn the key on.Port engine is ok. Switched indicator panel with working unit and it lights up. No 12v at the connector on stbd engine. Where to start looking??? Greg
  4. B

    Coil sealing grommet

    Changing plugs on 04 BF150 removing coil on #2 the rubber seal came off and remains on plug. can't get it out. Do I need to remove cover? how does the sleeve come out of cal head? Thanx Greg
  5. B

    2004 BF 150 no pee

    When hooked up to hose at flush line pee hole drips and have heavy flow out the prop hub. Ran engine at dock for about 20 minutes at 2000rpm with no problem. System operated normally last season but pee was a little weak at idle. Preseason did the following New water pump (complete)...
  6. B

    separating dual binnacle BF150

    Changing the shift/throttle cables on dual BF150. Never did this before so I have some questions. Would like to do one engine at a time, is this possible or do I have to pull all 4 cables at the same time. Stbd engine is derigged at this time, changing the rigging tube and ends, both tubes are...
  7. B

    2004 BF 150 no start

    I have a no start condition on 1 of my engined. Ran up the engine to warmup for oil change (about 20 min at idle) shut down, changed oil and filter.After refill started engine, ran for about 20 secs, sputtered and stalled would not restart. Replaced fuel ball pumped up still no start. Removed...
  8. B

    BF150 low pressure pump

    Is the low pressure pump rebuildable on a 2004 BF150
Back
Top