Logo
FULL SITE MENU

Search results

  1. S

    Johnson Evinrude 115 hp model J115PXSOR

    Hi y’all my engine dies out at low idle..a lot if I control it from under the hood it is fine. I would just like to set the idle up a little about the thickness of a razor blade it isnt much but I don’t need a whole lot going to try to add a photo wondering if this is where I can set idle up a...
  2. S

    2005 Johnson 115 hp 2 stroke dies easily at low idle

    I am not sure how to advance the idle and don’t have a timing light. But I think if I raised the idle just a tad it wouldnt always be dying while trying to maneuver slowly like when trying to to load onto trailer or floating slowly in toward a dock. Having to restart several times during slow...
  3. S

    Fuel type 2005 Johnson 115 hp 2cycle

    How many use the e85 fuel in this motor
  4. S

    Scuppers

    I have the type with the little ping pong ball in them they don’t seal off water worth a darn and allows the well to take water which in turn goes under a hatch to the bilge pump. Constant cycling water. I think it cannot be stock to have a hatch in a water well anyway but there it is bad seal...
  5. S

    Motor tilt intermittent

    weird won’t always work and if it starts to act like it won’t lift hittin up/down lever quickly seems to make a difference. Will low Hydralic fluid in the pump cause that? Sometimes it will groan while lifting. Seems like it works 90% of the time. The ten percent is at the ramp or in low water...
  6. S

    Steering difficult 2005 evinrude 115 hp on a 96 winner CC

    Weird thing steers easy to the right and hard to the left. All grease been done. Unless you are at idle and then both are easy
  7. S

    2005 Johnson 115 hp 2 stroke. Identify a bolt?

  8. S

    2 cycle mix

    How many of you all fill the tank with fuel and then add the proper amount of oil after ? Will it mix well enough? Currently I put oil in a 5 gallon container and fill the container and then dump inboard tank
  9. S

    1986 Evinrude Johnson 90hp model E90TXCDC power.

    Tuesday took it out to run some tests on the charging system. Ran up and down the water for more than an hour wide open throttle. Loaded it up went home fairly pleased with the way it ran. Took it out Wednesday and for the first hour ran great and then after sitting and fishing a bit, it started...
  10. S

    Rectifier location E90TXCDC Evinrude’86

    Not sure where it is and it looks like I don’t have one from everything I can find on it. But I don’t think I’m getting the battery recharged and can’t figure out how it runs without one
  11. S

    Evinrude/johnson model E90TXCDC torque specs

    I would like to get torque values for the stator bolts and also the flywheel nut.
  12. S

    ‘86 model E90txcdc fuel starved?

    Back story, on board fuel tank was foul. Previous owners let gas cap seal go bad allowing moisture. Added different fuel and heat product and removed the same on three occasions with weeks between each. The last time was a bottle of heat only. A month later added new fuel. Have installed a...
  13. S

    Fuse?

    What size in line fuse is needed from starter solenoid to switch? someone (PO?) Put a 14 amp in there and the holder is gapped open allowing moisture in. The next smaller size I find is a 9 amp and even it is pretty long 7.5 is the same length as the 9amp. just wondering what everyone else...
Back
Top