Logo
FULL SITE MENU

Search results

  1. M

    Honda BF115 won't shift after lower unit installed

    Hi I unfortunately did the exact same thing and gears aren’t right afterwards. Could you explain further how to redline please mate? Also I can’t see where #13 goes? I’ve replaced #54. Cheers for any and all help
  2. M

    Honda BF150a

    Cheers for that mate.I’ll order one up tomorrow
  3. M

    Honda BF150a

    I’ve an over hearing problem with my BF 135a . Today as I was changing the grommets on the drive shaft from the lower end I decided to check the water pump again. All looked good but I removed the base plate and underneath at the base of the drive shaft is a cylindrical shaped unit with 2 10m...
  4. M

    Honda BF135a Overheating if we go over 4k RPM

    Tgsnks for that. Do you have to remove the mid section to change them? I’m guessing yes and is there anything I need to be weary of if I remove it? Cheers
  5. M

    Honda BF135a Overheating if we go over 4k RPM

    Hi I have checked water pump and housing both brand new. She’s pumping water but looks a bit weak. I’ve changed both thermostats, 3 water sensors and the popppet valve. Cheers
  6. M

    Honda BF135a Overheating if we go over 4k RPM

    I’ve been reading that there is a grommet that can be replaced in the mid section? Can someone show me where it is please and do you have to remove the mid section to replace it? Attached is a pic of mine.
  7. M

    Honda 150 BAPJ 13000572 overheating at 4.000 rpm

    I know this is an old thread but could someone show me exactly where that grommet is? I think I found it but it looks very awkward to do!
Back
Top