Logo
FULL SITE MENU

Latest activity

What's new New posts Latest activity
  • J
    JOHNSON1102 replied to the thread Prop continuity washer.
    Yes and yes and it’s the 2pin style and just use the flat tab washer to lock in place. Thank you so much for your time and knowledge...
  • D
    Droid replied to the thread Prop continuity washer.
    Ok, follow closely: *Does yours have the 2 pins as pictured or the castle style center sleeve? Pins/Castle? *Does the metal sleeve...
  • S
    Skinny1 posted the thread 2003 yamaha 90 4 stroke hesitation at mid throttle in Yamaha Outboard Forum.
    Hello Have a 2003 90hp 4 stroke. Have had the carbs cleaned and synchronized. Still have a hesitation/ stumble between 2000 and 3000...
  • J
    JOHNSON1102 replied to the thread Prop continuity washer.
    So that gray piece is inserted into the black piece that has the splines that go into the center of the prop . What I have it appears to...
  • J
    JOHNSON1102 replied to the thread Prop continuity washer.
    Yes it has a metal removal sleeve that goes in the center of prop, 1 piece
  • D
    Droid replied to the thread Prop continuity washer.
    Doesn't that prop have the removable splined sleeve & plastic or hard rubber squarish hub? Like this picture? Some early removable hubs...
    • 1782609014327.jpeg
  • J
    JOHNSON1102 replied to the thread Prop continuity washer.
    Yes it’s a Mercury prop, 0A1912X 17 p quicksilver diamond this stamped is on the prop.
  • D
    Droid replied to the thread Prop continuity washer.
    Part # of prop you are trying to put on? Is it indeed the correct prop for a Mercury and not a different brand of motor?
  • D
    Droid replied to the thread Prop continuity washer.
    I assume your "1999" motor is a V-6 2 stroke? If yes, then it is the 4 3/4" gearcase & uses the same props & hardware as a Mercruiser...
  • J
    JOHNSON1102 replied to the thread Prop continuity washer.
    What you show is what I have exactly ! I may have wrong hardware perhaps. Guy said motor is a 1999 150 hp Mercury has salt water series...
  • D
    Droid replied to the thread Prop continuity washer.
    This is everything required for the "Black Max" style prop. If earlier, then the earlier thrust hub is required. Really need pictures of...
    • 1782607526609.jpeg
  • D
    Droid replied to the thread Prop continuity washer.
    I can't see your mismatch of parts. If I was there it would be immediately obvious.
  • D
    Droid replied to the thread Prop continuity washer.
    Your "Castle" washer looks like this?
    • 1782607273595.jpeg
  • J
    JOHNSON1102 replied to the thread Prop continuity washer.
    Ok I checked the thrust washer it solid wit a lip fits perfectly on back of prop. Took thrust washer off and put prop back on to see if...
  • D
    Droid replied to the thread Prop continuity washer.
    Later "Black Bax" style. Still used on current production units. Old style pictured above is bronze with a stainless washer. "Black Max"...
    • 1782606033647.jpeg
Show older items
Back
Top